Usage:
Start By:
a. remove water pump
b. remove air compressor and accessory drive (later)
c. remove oil pan
d. remove crankshaft front seal and wear sleeve
e. remove engine front support
2. Remove six accessory drive covers to timing gear cover bolts (1).
3. Remove two fuel injection pump housing to timing gear cover bolts (2) and two plates to cover bolts (3).
4. Remove the five timing gear covers to cylinder block bolts, and remove timing bear cover (4).
5. To install be sure that O-ring seal (5) is in position in the timing gear plate as shown.
6. Put a new gasket in position, and install timing gear cover (4) over the two dowel pins in the cylinder block.
7. Install the bolts that hold the timing gear cover to the cylinder block. Cut the cover gasket to make it even with the surface of the cylinder block and bottom of the timing gear cover.
8. Install the bolts that hold the accessory drive cover to the timing gear cover. Install the fuel injection pump housing to timing gear cover bolts and two plates to cover bolts.
9. Install the support plate that fastens the upper timing gear cover to the cylinder head assembly.
End By:
a. install engine front support
b. install crankshaft front seal and wear sleeve
c. install oil pan
d. install air compressor and accessory drive (later)
e. install water pump