Chain (Drag Conveyor) - Remove and Install
Start By:
- Remove the wheel (rear). Refer to Disassembly and Assembly, "Wheel (Rear) - Remove and Install".
- Remove bolts (2) and guard (1).
Show/hide table
Illustration 2 g01202154 - Loosen bolts (3).
- Loosen nut (4) and bolt (5).
Show/hide table
Illustration 3 g01202161 - Remove cotter pin (6), plate (8), and link (7) from chain (9).
- Remove chain (9) from the machine.
Show/hide table
Illustration 1 | g01202149 |
- Install chain (9) on the machine.
- Install link (7), plate (8), and cotter pin (6) in chain (9).
Show/hide table
Illustration 5 g01202154 - Tighten bolt (5), nut (4), and bolts (3). Refer to Operation and Maintenance Manual for the correct procedure.
Show/hide table
Illustration 6 g01202149 - Install guard (1) and bolts (2).
Show/hide table
Illustration 4 | g01202161 |
End By:
- Install the wheel (rear). Refer to Disassembly and Assembly, "Wheel (Rear) - Remvoe and Install".
Caterpillar Information System:
AP-1000D and BG-260D Asphalt Pavers Machine Systems Piston Motor (Drag Conveyor) - Install
793D Off-Highway Truck Power Train Pressure Sensor (Final Drive Oil)
793D Off-Highway Truck Hydraulic Fan System Piston Pump (Hydraulic Fan) Pressure - Test and Adjust
AccuGrade® Laser (CB420) MID 114 - CID 2259 - FMI 07
2005/09/12 New Procedures Improve the Service Life of the Check Valve {5051, 5067}
IT62H Integrated Toolcarrier and 950H and 962H Wheel Loaders Machine Systems Lift Cylinder - Remove and Install
420E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Transmission (Power Shift) Transmission
C15 and C18 Engines for Caterpillar Built Machines Water Temperature Regulator Housing
AP-1000D and BG-260D Asphalt Pavers Machine Systems Piston Motor (Drag Conveyor) - Remove
C4.4 and C6.6 Engines for Caterpillar Built Machines ECM Harness Connector Terminals
C15 Generator Set Engines E255 Diagnostic Reset
C15 Generator Set Engines Ether Injection System - Test
Topcon® System Five Specifications
414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E and 444E Backhoe Loaders Axles, Differential and Brakes Differential
C27 and C32 Generator Set Engines Poor Acceleration or Response
D7G Series 2 and D7G Series II Track-Type Tractors Lubricant Viscosities
AP-1000D and BG-260D Asphalt Pavers Daily Inspection
AP-1000D and BG-260D Asphalt Pavers Machine Systems Feeder Drive Shaft Group - Remove
AP-1000D and BG-260D Asphalt Pavers Machine Systems Feeder Drive Shaft Group - Install
R1300G and R1300G Series II Load Haul Dumps Hydraulic System Accumulator (Ride Control)
R1300G and R1300G Series II Load Haul Dumps Hydraulic System Accumulator (Ride Control)
R1300G Series II Load Haul Dump Power Train Relief Valve (Transmission Hydraulic Control)
C4.4 and C6.6 Industrial Engines and Engines for Caterpillar Built Machines Multiposition Switch Setup
AP-1000D and BG-260D Asphalt Pavers Propel System Front Wheel Assist