Piston Pump (Saw) - Install
Installation Procedure
- Attach a suitable lifting device and install pump (9). The weight of piston pump (9) is approximately 40 kg (90 lb). Install bolts (8). Connect tube assembly (7) .
Show/hide table
Illustration 1 | g01139245 |
- Attach manifold (2) and install bolts (5). Connect hose assembly (1), hose assembly (4), and hose assembly (3). Install tube assembly (5) .
Show/hide table
Illustration 2 | g01016784 |
- Fill the hydraulic oil system. Refer to the appropriate Operation and Maintenance Manual, "Hydraulic System Oil - Change".
- Close the engine hood. Refer to the Operation and Maintenance Manual, "Hood - Tilt".
Caterpillar Information System:
Oil Volumes for Track Link Assemblies {4169} Oil Volumes for Track Link Assemblies {4169}
TK741, TK751 and TK752 Track Feller Bunchers Machine Systems Piston Pump (Saw) - Remove
2005/04/11 A Special instruction, REHS2561, "Field Installation of the 255-7115 Equalizer Bar As " Is Available {7206}
C7 Engine for AP-1000D, AP-1055D, BG-2455D, and BG-260D Asphalt Pavers E362 Engine Overspeed
AP1055D and BG2455D Asphalt Pavers Engine Supplement Gear Pump (Fan Drive) - Assemble
C9 Engine for Caterpillar Built Machines System Configuration Parameters
Installing the 266-9184 Cab Heater and Mounting Kit {7304} Installing the 266-9184 Cab Heater and Mounting Kit {7304}
Topcon® System Five General Hazard Information
C27 and C32 Engines for Caterpillar Built Machines E361 High Engine Coolant Temperature
539 Knuckleboom Loader Reference Material
994F Wheel Loader Bucket Wear Plates - Inspect/Replace
740 and 740 EJECTOR Articulated Trucks Power Train Power Train Hydraulic System
R2900G Load Haul Dump Bucket Control Group Safety Pins
R2900G Load Haul Dump Braking System Parking Brake - Manual Release
R2900G Load Haul Dump Starting the Engine
R2900G Load Haul Dump Engine and Machine Warm-Up
R2900G Load Haul Dump Braking System Pressure Switch (Service Brake Oil)
R2900G Load Haul Dump Stopping the Machine
C11 and C15 Engines for Caterpillar Built Machines 5 Volt Engine Pressure Sensor Supply Circuit - Test
2005/01/31 Procedure for Installing the Topcon 5 Contact Sensor {7220}
TK741, TK751 and TK752 Track Feller Bunchers Machine Systems Felling Head - Remove
TK741, TK751 and TK752 Track Feller Bunchers Machine Systems Felling Head - Install
539 Knuckleboom Loader Fuel Tank Cap and Strainer - Clean
C11 and C15 Engines for Caterpillar Built Machines Cat Data Link Circuit - Test