Gear Pump (Implement, Pilot, Brake) - Install
安装步骤
- 将适当的提升装置连接到齿轮泵 (8) 。 齿轮泵 (8) 的重量约为 68 kg (150 lb)。
Show/hide table
 | |
| 图 1 | g01134037 |
Show/hide table
 | |
| 图 2 | g01134035 |
- 使用适当的起吊设备安置齿轮泵 (8) 。 安装螺栓 (9) 。
- 连接软管组件 (6) 并安装螺栓 (7) 。
Show/hide table
 | |
| 图 3 | g01134033 |
- 连接软管组件 (5) 并安装螺栓 (4) 。
Show/hide table
 | |
| 图 4 | g01134032 |
- 用液压油加注管组件 (3) 。 连接管组件 (3) ，然后安装螺栓 (2) 。
Show/hide table
 | |
| 图 5 | g01134031 |
- 用液压油加注齿轮泵。
Show/hide table
| 注意 |
|---|
为避免损坏系统，请确保在起动前适当地给液压泵加注液压油。 |
- 关闭驾驶室后面的检修门 (1) 。
Show/hide table
 | |
| 图 6 | g01135339 |
- 加注液压油系统。 请参阅拆解和组装, "润滑剂粘度和加注容量"。
End By: 分离转向机架锁。 请参阅 拆解和组装, "转向机架锁 - 分离和连接"。
Caterpillar Information System:
834H Wheel Dozer and 836H Landfill Compactor Machine Systems Gear Pump (Implement, Pilot, Brake) - Remove
AP1055D and BG2455D Asphalt Pavers Engine Supplement Exhaust (Muffler) - Remove and Install
988G Wheel Loader Power Train Output Transfer Gears - Disassemble
735 Articulated Truck Jacking/Blocking Locations
C11 and C15 Engines for Caterpillar Built Machines CID 0275 FMI 04 Right Turbo Inlet Pressure short to ground
C11 and C15 Engines for Caterpillar Built Machines CID 0275 FMI 03 Right Turbo Inlet Pressure open/short to +batt
C7 Engines for Caterpillar Built Machines Engine Oil Pressure - Test
307D, 311D, 312D, 313D, 315D, 318D, 319D, 320D, 323D, 324D, 325D, 326D, 328D, 329D, 330D, 336D, 340D, 345D, 349D, 374D, 390D and M325D Excavators Air Conditioning and Heating Air Conditioning E12 - Recirculation Sensor (Short Circuit)
C7 Engines for Caterpillar Built Machines Turbocharger - Inspect
C7 Engines for Caterpillar Built Machines Fuel System Pressure - Test
735 and 740 Articulated Trucks Cab - Tilt
2005/02/07 Additional Information for the Operation and Maintenance Manual {7254, 7256}
834H Wheel Dozer and 836H Landfill Compactor Machine Systems Seat - Remove
834H Wheel Dozer and 836H Landfill Compactor Machine Systems Seat - Install
834H Wheel Dozer and 836H Landfill Compactor Electrohydraulic System Position Sensor for the Joystick Control (Operator Monitor) - Calibrate
834H Wheel Dozer and 836H Landfill Compactor Machine Systems Steering Cylinder - Remove and Install
834H Wheel Dozer and 836H Landfill Compactor Electrohydraulic System Position Sensor for the Lift Linkage (Electronic Technician) - Calibrate
834H Wheel Dozer and 836H Landfill Compactor Electrohydraulic System Position Sensor for the Lift Linkage (Operator Monitor) - Calibrate
2005/01/24 Correction to Disassembly and Assembly , "Assemble Brake, Steering and Pilot Pump" {4306}
R2900G Load Haul Dump Hydraulic System Main Hydraulic System
R2900G Load Haul Dump Hydraulic System Ride Control System
R2900G Load Haul Dump Steering System General Information
307D, 311D, 312D, 313D, 315D, 318D, 319D, 320D, 323D, 324D, 325D, 326D, 328D, 329D, 330D, 336D, 340D, 345D, 349D, 374D, 390D and M325D Excavators Air Conditioning and Heating Air Conditioning E13 - Fresh Air Sensor (Open Circuit)
C15 and C18 Engines for Caterpillar Built Machines Coolant Flow Switch Circuit - Test