216B, 216B2, 226B, 226B2, 232B, 232B2, 242B and 242B2 Skid Steer Loaders Machine Systems Caterpillar

Removal Procedure

Start By:

1. Release the pressure in the hydraulic oil system. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release" for more information.

Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.

Show/hide table



Illustration 1	g01060321

1. Disconnect harness assembly (1). Disconnect hose assemblies (2), (3), (4) and (7). Remove bolts (6) and remove solenoid valve (5) .

Show/hide table



Illustration 2	g01050905

2. Note the orientation of fittings (12) and (13) for installation purposes. Remove nut (8), coil assembly (9), valve assembly (10) and fittings (11) .

   Note: Check the condition of the O-ring seals for wear or damage. Replace the O-ring seals, if necessary.

Installation

Show/hide table



Illustration 3	g01050905

1. Install valve assembly (10), coil assembly (9), nut (8), and fittings (11). Tighten valve assembly (10) to a torque of 31 ± 4 N·m (23 ± 3 lb ft). Tighten nut (8 ) to a torque of 14 ± 2 N·m (10 ± 1 lb ft). Install fittings (12) and (13). Be sure that fittings (12) and (13) are in the correct orientation.

   Note: Check the condition of the O-ring seals for wear or damage. Replace the O-ring seals, if necessary.

Show/hide table



Illustration 4	g01060321

2. Install solenoid valve (5). Install bolts (6). Connect harness assembly (1). Connect hose assemblies (2), (3), (4) and (7) .