Usage:
NOTE: For removal and installation of the later folded core radiator, see Remove And Install Radiator (Earlier) in this module. The procedures are basically the same.
Disassemble Radiator (Later-Folded Core)
START BY:
a. remove radiator (later-folded core)
1. Remove the fan guard.
2. Remove four shields (1).
3. Remove plate assemblies (2).
4. Install two 1/2"-13 NC forged eyebolts (3) into radiator top tank (4). Fasten chains and a hoist to the forged eyebolts. The weight of the radiator tank is 50 kg (110 lb.).
5. Remove the bolts that hold the radiator top tank to the channel assemblies.
6. Remove the nuts and washers from the studs on the radiator top tank. The studs fit into slots in the channel assemblies.
7. Carefully lift the radiator top tank off the core assemblies.
8. At the front of the radiator, remove the bolts that hold the core assemblies to plate assembly (5).
9. At each side of the radiator, remove the bolts that hold the outer core assemblies to the bracket assemblies.
10. At the front of the radiator, remove seven strap assemblies.
11. Remove the core assemblies from the radiator bottom tank.
12. Remove the seals from the radiator top tank and radiator bottom tank.
13. Inspect and replace damaged parts as necessary.
Assemble Radiator (Later-Folded Core)
NOTICE |
---|
Seals (1) and (2) are different. The top seals have a longer tab spacing than the bottom seals. Be sure the tabs engage with the holes in the tanks. |
1. Apply liquid soap to the sealing areas of seals (1), and install them in the radiator top tank.
2. Apply liquid soap to the sealing areas of seals (2), and install them in the radiator bottom tank.
3. Install core assemblies (3) into the seals in the radiator bottom tank. Install the core assemblies with the bevel edges together.
4. Install the bolts and washers that hold the core assemblies to plate assembly (4), but do not tighten them at this time.
5. Install the bolts and washers that hold the outer core assemblies to the brackets, but do not tighten the bolts at this time.
6. Install the bolts and washers that hold the core assemblies to strap assemblies (5) and (6). Do not tighten the bolts at this time.
7. Carefully lower the radiator top tank into position on the core assemblies.
8. Install the top tank to the core assemblies and the channel assemblies. Install the bolts, washers and nuts, but do not tighten them at this time.
9. Adjust the air gap between the core assemblies at the front of the radiator to 5 to 8 mm (.197 to .315 in.).
10. Tighten the bolts as the adjustments for each set of core assemblies is made.
11. After the air gap for all the core assemblies has been established. Tighten the remaining bolts.
12. Complete the assembly of the radiator.
END BY:
a. install radiator (later-folded core)