Component Location
Show/hide table
Illustration 1 | g01238953 |
Block diagram |
Show/hide table
Illustration 2 | g01238957 |
Component locations (typical left side engine view) (1) Intake manifold pressure sensor (2) Injector valve cover entry connector (3) Inlet manifold air temperature sensor (4) Fuel pressure sensor (5) Fuel temperature sensor (6) Secondary engine speed/timing sensor (7) Primary engine speed/timing sensor (8) Timing calibration port (9) Atmospheric pressure sensor (10) Engine oil pressure sensor (11) Engine Control Module (ECM) (12) J2/P2 ECM connector (13) J1 ECM connector |
Show/hide table
Illustration 3 | g01238958 |
Component locations (typical right side engine view) (14) Engine coolant temperature sensor (15) Engine oil temperature sensor |
Caterpillar Information System:
C15 and C18 Petrolem Generator Set Engines Configuration Parameters
G3520B Engine Sensors and Electrical Components
C9 Petroleum Engines Turbocharger
G3520B Industrial Engines Sensor Signal (Analog, Passive) - Test
C15 and C18 Petrolem Generator Set Engines Diagnostic Trouble Codes
G3520B Engine Specifications
G3520B Engine Product Description
3608 Engine Piston and Connecting Rods - Install
3608 Engine Piston and Connecting Rods - Remove
C3.3 Industrial Engine Engine Design
C3.3 Industrial Engine Cylinder Head Valves
3608 Engine Piston Cooling Jets - Remove and Install
2007/10/29 Improved Securing of the Wiring Harness {1408}
C175-16 Locomotive Engine Fuel Lines - Fuel Lines for the High Pressure Fuel Pump
C27 and C32 Tier 4 Engines Flywheel Housing
C27 and C32 Industrial and Petroleum Engines Flywheel Housing
C27 and C32 Industrial and Petroleum Engines Flywheel Housing
G3520B Engine Refill Capacities and Recommendations
2007/10/08 Improved Exhaust Riser Brackets are Now Available {1059, 1154}
2007/10/22 A New Spring Helps to Relieve Combustion Pressure {1550}
Specifications and Reusability for Hydraulic Gear Pumps and Motors (Groups 9, 10, and 11) {5061, 506G, 5073} Specifications and Reusability for Hydraulic Gear Pumps and Motors (Groups 9, 10, and 11) {5061, 506G, 5073}
2007/10/01 Improvements for the Engine Oil Cooler Are Now Used {1378, 1380}
2007/10/08 Improvements for the Engine Oil Cooler Are Now Used {1378}
2007/10/01 Improvements for the Engine Oil Cooler Are Now Used {1378}