Illustration 1 | g01609413 |
Rear view of the engine |
Note: Before installation of the flywheel housing, inspect the front face of the flywheel housing and the rear face of the rear housing. The components must be free of the following substances: oil, fuel, water, assembly compounds and any other contaminants
Use the following procedure to tighten the flywheel housing bolts:
- Tighten the bolt (1) through bolt (2) in the numerical sequence that is shown in Illustration 1 to
55 ± 10 N·m (41 ± 7 lb ft) . These bolts are 3/8-16 X 4 3/4 inches. - Tighten the bolt (3) through bolt (10) in the numerical sequence that is shown in Illustration 1 to
135 ± 20 N·m (100 ± 15 lb ft) . These bolts are 1/2-13 X 5 inches. - Tighten the bolt (11) through bolt (34) in the numerical sequence that is shown in Illustration 1 to
47 ± 9 N·m (35 ± 7 lb ft) . These bolts are 3/8-16 X 2 1/2 inches.
Illustration 2 | g01609414 |
Section A-A |
Note: Check assembled installation depth of the crankshaft seal group with the crankshaft at maximum rearward position.
(B) Assembled installation depth of the crankshaft seal group ...
Note: The seal and the sleeve of the crankshaft seal group must not be used if the seal and the sleeve have been separated.
(35) The seal driver must not contact the seal within the following diameter. ...