Connecting Rod Bearings - Remove - Connecting rods in position
开始:
- 拆下吸油管。 请参阅拆解和组装, "发动机机油泵 - 拆卸"。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
注: 如果需要更换四缸发动机上的所有连杆轴承,可以同时在两个气缸上进行本步骤。 本程序可在下列气缸配对上同时进行。 1 与 4 和 2 与 3。 确保在从一对气缸换到另一对气缸之前安装完两对连杆轴承。 请参阅拆解和组装, "连杆轴承 - 安装"。
- 转动曲轴,直至活塞处于底部中心位置。 拆下螺母 (6) 并将连杆盖 (5) 从连杆 (1) 上拆下。
- 将下连杆轴承 (4) 从连杆盖 (5) 上拆下。
- 小心地将连杆 (1) 推入气缸孔中。 从连杆上拆下连杆上轴承 (3)。
注: 在连杆螺栓 (2) 上用胶带或橡胶管保护曲轴轴颈。 连杆螺栓的锋利边缘会损坏曲轴轴颈。
Show/hide table
图 1 | g01317759 |
典型示例 |
注: 连杆和连杆盖的匹配数字位于 (X) 位置。 如有必要,在连杆 (1) 和连杆盖 (5) 上作临时标记。
Caterpillar Information System:
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Connecting Rod Bearings - Install - Connecting rods in position
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Camshaft - Remove
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Camshaft - Install
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Camshaft - Disassemble
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Camshaft - Assemble
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Alternator - Remove and Install - 65 Amp and 85 Amp Alternators
C13 On-highway Engine Air Lines
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Alternator - Remove and Install - 55 Amp Alternator
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Alternator - Remove and Install - 40 Amp Alternator
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Alternator - Remove and Install - 14 Amp and 15 Amp Alternators
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Engine Oil Line - Remove and Install
C13 On-highway Engine Air Lines
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Coolant Temperature Switch - Remove and Install - C0.5 and C0.7 Engines
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Coolant Temperature Switch - Remove and Install - C1.1, C1.5, C1.6 and C2.2 Engines
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Crankcase Breather - Remove and Install - Naturally Aspirated Engines
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Crankcase Breather - Remove and Install - Turbocharged Engines
G3520C and G3520E Generator Set Engines Turbocharger Compressor Bypass - Test
G3520C and G3520E Generator Set Engines Detonation - Test
C11 and C13 Engines and 14M and 16M Motor Graders CAN Data Link - Test
G3520C and G3520E Generator Set Engines Electrical Power Supply - Test
C9 Engines for Motor Graders Fuel Filter Differential Pressure - Test
C11 and C13 Engines and 14M and 16M Motor Graders Fuel Filter Is Restricted
Determining the Cause of Fuel Dilution of Engine Oil {1101, 1124, 1251, 1280, 1290} Determining the Cause of Fuel Dilution of Engine Oil {1101, 1124, 1251, 1280, 1290}
C13 On-highway Engine Air Lines