C11 and C13 Engines and 14M and 16M Motor Graders Caterpillar


Fuel Filter Is Restricted

Usage:

16M B9H
ECM(Electronic Control Module,电子控制模块)检测到燃油滤清器差压异常。

如果下列事件代码激活,采用此步骤。 有关事件代码和此代码的默认触发点的信息,请参阅故障诊断与排除, "事件代码"。 必须进入 Caterpillar ET(Electronic Technician,电子技师)的监控系统才能查看此代码的当前触发点。

表 1
事件代码    
代码和描述     产生此代码的状况     系统响应    
E390(1) 燃油滤清器阻塞     经过过滤的燃油压力与未经过滤的燃油压力之差大于触发点压力。 该事件代码的延迟时间为一小时。     将会记录该代码。    
E390(2) 燃油滤清器阻塞     经过过滤的燃油压力与未经过滤的燃油压力之差大于触发点压力。 该事件代码的延迟时间为一小时。     发动机 ECM 会使发动机功率减额。 将会记录该代码。    

可能原因

  • 燃油滤清器滤芯

建议的措施

燃油滤清器滤芯

  1. 更换燃油滤清器滤芯。

  1. 重新起动发动机。

  1. E390(1) 事件代码的延迟时间为 1 小时。 如果更换燃油滤清器后不久事件代码变为激活状态,则故障可能是电气故障。 有关对油路进行故障诊断与排除的步骤,请参阅故障诊断与排除, "燃油滤清器压差 - 测试"。

Caterpillar Information System:

C9 Engines for Motor Graders Fuel Filter Differential Pressure - Test
G3520C and G3520E Generator Set Engines Electrical Power Supply - Test
C11 and C13 Engines and 14M and 16M Motor Graders CAN Data Link - Test
G3520C and G3520E Generator Set Engines Detonation - Test
G3520C and G3520E Generator Set Engines Turbocharger Compressor Bypass - Test
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Crankcase Breather - Remove and Install - Turbocharged Engines
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Crankcase Breather - Remove and Install - Naturally Aspirated Engines
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Coolant Temperature Switch - Remove and Install - C1.1, C1.5, C1.6 and C2.2 Engines
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Coolant Temperature Switch - Remove and Install - C0.5 and C0.7 Engines
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Connecting Rod Bearings - Remove - Connecting rods in position
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Connecting Rod Bearings - Install - Connecting rods in position
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Camshaft - Remove
Determining the Cause of Fuel Dilution of Engine Oil {1101, 1124, 1251, 1280, 1290} Determining the Cause of Fuel Dilution of Engine Oil {1101, 1124, 1251, 1280, 1290}
C13 On-highway Engine Air Lines
C11 and C13 Engines and 14M and 16M Motor Graders Fuel Transfer Pump - Test
G3520C and G3520E Generator Set Engines Fuel Control - Test
C13 On-highway Engine Air Lines
C11 and C13 Petroleum Engines Air Lines
G3520C and G3520E Generator Set Engines Fuel Metering Valve - Test
2006/10/02 Use Only Cleaning Agents that are Water Based with the 212-1503 Parts Washer Kit {0680}
G3520C and G3520E Generator Set Engines Ignition Primary - Test
G3520C and G3520E Generator Set Engines Ignition Secondary - Test
Bench Test Procedure for Hydraulic Piston Pumps {5070} Bench Test Procedure for Hydraulic Piston Pumps {5070}
C15 On-Highway Engine Exhaust Manifold
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.