Cylinder Head - Inspect
Show/hide table
Required Tools | ||
---|---|---|
Part Number | Part Name | Qty |
8S-6691 | Cylinder Head Stand Set | 1 |
Show/hide table
Illustration 1 | g00907442 |
Bolt tightening sequence for the C1.5/3013C engines |
Show/hide table
Illustration 2 | g00907444 |
Bolt tightening sequence for the C2.2/3024C engine |
- Remove the bolts in the cylinder head in the reverse sequence that is shown in Illustrations 1, 1 and 2.
Remove the cylinder head from the engine.
- Clean the cylinder head thoroughly. Make sure that the contact surface of the cylinder head and the contact surface of the cylinder block are clean, smooth, and flat.
- Inspect the bottom surface of the cylinder head for pitting, corrosion, and cracks. Inspect the area around the valve seats and the holes for the fuel injection nozzles.
Show/hide table
Illustration 3 g00842292 Typical example - Put cylinder head (1) on the 8S-6691 Cylinder Head Stand Set (2).
Show/hide table
Illustration 4 g00907448 Typical example - Use a straight edge and a feeler gauge to check the six positions of the cylinder head for distortion. Refer to Specifications, "Cylinder Head" for the requirements of flatness.
Caterpillar Information System:
C2.2 Engine Glow Plugs
C2.2 Engine Engine Oil Pressure Switch
C2.2 Engine and C1.5 Generator Set Piston Ring Groove - Inspect
C2.2 Engine Gear Group (Front)
C2.2 Engine Piston and Rings
C2.2 Engine Connecting Rod Bearing Journal
C2.2 Engine Crankshaft
C2.2 Engine Water Temperature Regulator
C2.2 Engine and C1.5 Generator Set Engine Valve Lash - Inspect/Adjust
C2.2 Engine Engine Oil Relief Valve
C2.2 Engine Exhaust Manifold
C2.2 Engine Cylinder Head
2005/10/10 A New Fuel Level Switch Is Now Being Used {1435, 7481}
C2.2 Engine and C1.5 Generator Set Glow Plugs - Test
C2.2 Engine Fuel Injection Timing - Check
C2.2 Engine Engine Valve Lash - Inspect/Adjust
2006/10/30 Using Injector Trim Files {1290, 7620}
2006/10/30 Using Injector Trim Files {1251, 7620}
C7 On-highway Engine Belt Tensioner
C3.3 and C4.4 Generator Sets Crankshaft Rear Seal - Remove
C2.2 Engine Cylinder Head - Inspect
3406C Generator Sets Cold Weather Starting
C7 On-highway Engine Belt Tensioner
C3.3 and C4.4 Generator Sets Crankshaft Rear Seal - Install