Engine Oil Cooler - Remove
Show/hide table
| 注意 |
|---|
|
在检查、保养、测试、调整及维修产品时，请小心确保盛接油液。 在打开任何舱室或拆卸任何含有油液的部件前，请准备好盛接液体用的适当容器。 |
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 从冷却系统将冷却液排入合适的容器以便保存或废弃这些冷却液。 请参考操作和保养手册, "冷却系统冷却液 - 更换"。
Show/hide table
图 1 g01135600 - 拆下螺栓 (2)。 拆下弯头 (3) 和管组件 (1)。 从弯头上卸下密封垫。
- 从弯头 (3) 上卸下管组件 (1)。 从管上取下 O 形密封圈 (4)。
Show/hide table
图 2 g01135604 - 将适当的起吊设备连接到发动机机油冷却器 (7) 上。 发动机机油冷却器 (7) 的重量约为
78 kg (172 lb) 。 - 拆下螺栓 (8) 和螺栓 (9)。 将卡箍组件从管组件 (10)上拆下。
- 将管组件 (10)从冷却器旁通弯管上拆下。 将 O 形密封圈和挡圈从管组件上拆下。
- 拆下螺栓 (5) 和螺栓 (6)。 将接头 (11)从发动机机油冷却器上拆下。 从适配器上卸下密封垫。
- 拆下螺栓 (12)。
- 将发动机机油冷却器 (7)从管 (13)上拆下。 从管上拆下 O 形密封圈。
Caterpillar Information System:
3412E Petroleum Engine CID 1835 FMI 04 Auxiliary Pressure Sensor short to ground
3412E Petroleum Engine CID 1835 FMI 03 Auxiliary Pressure Sensor open/short to +batt
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Factory Passwords
C11 and C13 Engines for Caterpillar Built Machines Electric Starting Motor - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Alternator - Remove and Install
C4.4 Industrial Engine Overspeed
311B, 312B, 315B, 320B, 322B, 325B and 330B Excavators Air Conditioning and Heating Refrigerant Compressor Oil - Check
311B, 312B, 315B, 320B, 322B, 325B and 330B Excavators Air Conditioning and Heating Manifold Gauge Set (Refrigerant) - Install
311B, 312B, 315B, 320B, 322B, 325B and 330B Excavators Air Conditioning and Heating Required Tools
311B, 312B, 315B, 320B, 322B, 325B and 330B Excavators Air Conditioning and Heating Refrigerant Recovery
311B, 312B, 315B, 320B, 322B, 325B and 330B Excavators Air Conditioning and Heating Refrigerant System - Flush
3412E Petroleum Engine CID 0110 FMI 04 Engine Coolant Temperature short to ground
3508C, 3512C and 3516C Marine Engines Engine Oil Cooler - Install
3306B Industrial Engine Emergency Stopping
3500B Marine Propulsion Engines Auxiliary Water Pump - Inspect
Particulate Filter for Stationary Engines in Standby Applications{1091} Particulate Filter for Stationary Engines in Standby Applications{1091}
3406E, C12, C15 and C18 Marine Engines CID 0096 FMI 03 Fuel Level Sensor open/short to +batt
3406E, C12, C15 and C18 Marine Engines CID 0096 FMI 04 Fuel Level Sensor short to ground
C11 and C13 Engines for Caterpillar Built Machines Electronic Unit Injector - Remove
3516B and 3516B High Displacement Engines for 994D and 994F Wheel Loaders Fuel Filter Base - Electric Fuel Priming Pump
3508C, 3512C and 3516C Marine Engines Engine Oil Cooler - Disassemble
3508C, 3512C and 3516C Marine Engines Engine Oil Cooler - Assemble
345C Excavator Machine System Specifications Boom Cylinder
C11 and C13 Engines for Caterpillar Built Machines Electronic Unit Injector - Install