Electronic Unit Injector Sleeve - Install
Installation Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 4C-5552     | Large Bore Brush     | 1     |
B     | 9U-7237     | Brush Extension     | 1     |
9U-7244 | End Brush     | 1     | |
C     | 9U-7258     | Driver Cap     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use Tool (A) to clean the unit injector bore.
Show/hide table
Illustration 1 | g00512115 |
- Use Tool (B) to clean the unit injector seat.
Note: Check the fuel passage in the cylinder head assembly. Remove any debris left from the use of Tool (A) and Tool (B) .
- Apply 4C-9507 Retaining Compound to upper land (1) and lower land (2) on the unit injector sleeve.
- Position the unit injector sleeve in the cylinder head assembly. Use Tool (C) and a hammer to seat the sleeve.
Show/hide table
Illustration 2 | g00512116 |
Typical Example |
- Repeat Step 1 through Step 4 in order to install the remaining unit injector sleeves.
End By: Install the electronic unit injectors.
Caterpillar Information System:
3176C and 3196 Marine Engines Inlet and Exhaust Valves - Remove and Install
3176C and 3196 Marine Engines Inlet and Exhaust Valve Springs - Remove and Install
2000/02/01 Correction To Troubleshooting, SENR5015-00 {1000}
3176C and 3196 Marine Engines Rocker Shaft and Pushrod - Remove
3176C and 3196 Marine Engines Valve Mechanism Cover - Remove and Install
3176C and 3196 Marine Engines Turbocharger - Install
2000/01/01 Plastic Cards With The Revised Procedure For Tightening Cylinder Head Bolts Will Be Distributed By Mail {1100}
2000/01/01 Plastic Cards With The Revised Procedure For Tightening Cylinder Head Bolts Will Be Distributed By Mail {1100}
Programming The Electronic Ignition System (EIS) Control Module For The Manifold Air Pressure (MAP) Sensor.{1408, 1901} Programming The Electronic Ignition System (EIS) Control Module For The Manifold Air Pressure (MAP) Sensor.{1408, 1901}
2000/01/17 Plastic Cards With The Revised Procedure For Tightening Cylinder Head Bolts Will Be Distributed By Mail {1100}
3500 Generator Set Engines Auxiliary Drive Pulley
2000/01/01 Correction to Specifications Module, SENR5117-03, "3116 Diesel Truck Engine" {1201}
3176C and 3196 Marine Engines Cylinder Head - Remove
2000/01/01 New Idler Pulley Now Available {1358}
3512B Petroleum Engines High Coolant Temperature
2000/02/01 Shorter Bolts For Mounting The Radiator Support Brace To The Radiator Top Tank Are Used {1353}
3176C and 3196 Marine Engines Inlet and Exhaust Valve Guides - Remove and Install
3176C and 3196 Marine Engines Lifter Group - Remove and Install
3176C and 3196 Marine Engines Coolant Temperature Sensor - Remove and Install
3512B Petroleum Engines Altitude Derate Feature
3512B Petroleum Engines Crankcase Pressure
3512B Petroleum Engines Low Coolant Temperature
3512B Petroleum Engines Exhaust Temperature
3512B Petroleum Engines Fuel Filter Differential Pressure