Engine Oil Filter Base - Assemble
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install plunger (3).
- Install spring (4).
- Install plugs (2) that hold the valves in engine oil filter base (1). Tighten plugs (2) to a torque of
100 ± 15 N·m (74 ± 11 lb ft) .
Show/hide table
Illustration 1 | g01001860 |
Show/hide table
Improper assembly of parts that are spring loaded can cause bodily injury. To prevent possible injury, follow the established assembly procedure and wear protective equipment. |
Caterpillar Information System:
3500 Spark Ignited Engines Valve Mechanism
3176C and 3196 Industrial Engines Electronic Control Module - Remove and Install
3176C and 3196 Engines For Caterpillar Built Machines Crankshaft Gear - Remove and Install
3176C and 3196 Engines For Caterpillar Built Machines Camshaft Gear - Remove and Install
3176C and 3196 Engines For Caterpillar Built Machines Accessory Drive - Assemble
3406C (PEEC III) Truck Engines Cooling System
3176C and 3196 Engines For Caterpillar Built Machines Accessory Drive - Disassemble
3176C and 3196 Engines For Caterpillar Built Machines Crankshaft Rear Seal Carrier - Remove and Install
3500 Spark Ignited Engines Piston and Rings
3176C and 3196 Engines For Caterpillar Built Machines Turbocharger - Install
3176C and 3196 Engines For Caterpillar Built Machines Turbocharger - Remove
3114, 3116 and 3126 MUI Engine Governors Governor (Type I) - Disassemble
3176C and 3196 Engines For Caterpillar Built Machines Crankshaft Position Sensor - Remove and Install
3176C and 3196 Industrial Engines Compression Brake - Install
G3500B Engines Cylinder Head Valves
3406E On-Highway Engine Engine Oil Pump - Assemble
3176C and 3196 Engines For Caterpillar Built Machines Connecting Rod Bearings - Remove
3176C and 3196 Engines For Caterpillar Built Machines Connecting Rod Bearings - Install
C-10 and C-12 Engines Gear Group (Front) - Remove
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Remove
3406E On-Highway Engine Fuel Transfer Pump - Install
3500 Spark Ignited Engines Cylinder Head
C-10 and C-12 Engines Gear Group (Front) - Install
P16, P20, P25, P28, P40 and P60 Pulverizers Rotary Manifold - Remove