Installation Procedure
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 9U-6862 | Tapered Brush | 1 |
| 9U-7237 | Drill Extension | 1 | |
| B | 9U-6863 | Small Bore Brush | 1 |
| 9U-7237 | Drill Extension | 1 | |
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use Tool (A) to clean injector seating (1) .
 | |
| Illustration 1 | g00511917 |
(1) Injector seating (2) Tip bore | |
- Use Tool (B) to clean tip bore (2) .
- Lubricate the bore lightly with a 50/50 mix of clean engine oil and 8T-2998 Lubricant .
 | |
| Illustration 2 | g00511927 |
Note: Do not reuse seals (4). Use new seals for installation.
 | |
| Illustration 3 | g00511929 |
- Position the unit injector (3) in the cylinder head assembly. Place the hold down clamp (10) at the base of the unit injector. Push down on the return spring of the unit injector in order to seat the unit injector.
Note: The injector code will be used later if the injectors have been changed. Write down the injector code which is located on the solenoid.
 | |
| Illustration 4 | g00529729 |
(12) Electronic injector code | |
| NOTICE |
|---|
When a fuel injector group is serviced, the new fuel injector group's electronic injector code must be programmed into the engine's personality module software by using the calibration menu on the Electronic Service Tool. If the new fuel injector group's electronic code is not entered, the previous fuel injector group's characteristics are assumed. If it is not possible to immediately reprogram the electronic injector code of the injector into the personality module software, the engine will not be severely harmed. The new electronic injector code should be reprogrammed as quickly as possible in order to optimize engine performance. |
- Install spacer assembly (9) and bolt (8) that holds the unit injector in place.
- Pull the unit injector completely into the bore. Tighten the bolt to a torque of 30 N·m (22 lb ft).
- Install cap assembly (5). Tighten nuts (6) to a torque of 2.5 ± 0.25 N·m (22 ± 2 lb in).
- Install bridge assemblies (7) onto the valve stems.
- Install plug (11) in the fuel manifold.
 | |
| Illustration 5 | g00511936 |
End By: Install the rocker shaft and the pushrods. Refer to Disassembly and AssemblySENR9537, "Rocker Shaft and Pushrod - Install".