RM-250C Reclaimer Mixer and RM-350B and RR-250B Road Reclaimer/Soil Stabilizers Additive Spray System Caterpillar


Piston Pump Flow - Test

Usage:

RR-250B 3RR



Illustration 1g00895069

  1. Remove the cover of output shaft (1) .

  1. Put reflective tape on the shaft.

  1. Test the hydraulic pressure while the emulsion system is operating. You can also check the pressure with water. Read the pressure gauge.

  1. Use a phototach in order to measure the speed of the shaft.

  1. Use the following formula in order to approximately determine the GPM of the system.

    Table 1
    Method of determining the system GPM:    
    2.9     =     GPM    
    RPM Reading    

  1. Verify that the value from Step 5 is approximately equal to the GPM of the system on the control box.

Caterpillar Information System:

2002/06/10 Installing a Stiffener Plate to the Lift Cylinder Tube Assemblies Increases Service Life {5057}
R1600G Load Haul Dump Steering System Solenoid Valve (Reversible Steering)
R1600G Load Haul Dump Hydraulic System Pilot Control Valve
R1600G Load Haul Dump Steering System Pressure Reducing Valve (Steering Pilot)
2002/07/15 New Flash File Software Is Used for Product Link 151/201 {7606, 7620}
3056E Industrial Engine Coolant Temperature Sensor
2002/05/27 Engine Tool Lists And Machine Tool Lists Are Available On The Caterpillar Intranet {0600}
RM-250C, RR-250B and RM-350B Additive Spray System Additive Spray System Hydraulic Filter - Replace
797B Off-Highway Truck Filter and Screen Locations
RM-250C, RR-250B and RM-350B Additive Spray System Additive Spray System Pump - Lubricate
RM-250C, RR-250B and RM-350B Additive Spray System Additive Spray System Nozzles - Clean
834G Wheel Dozer and 836G Landfill Compactor Power Train Torque Converter Lockup Clutch Pressure - Test
RM-250C Reclaimer Mixer and RM-350B and RR-250B Road Reclaimer/Soil Stabilizers Additive Spray System Relief Valve (Charge) - Test and Adjust
814F Wheel Dozer, 815F Soil Compactor and 816F Landfill CompactorEngine Supplement Electronic Unit Injector - Remove
797B Off-Highway Truck Engine Air Precleaner - Clean
793C XQ Off-Highway Truck and 793C Off-Highway Truck Engine Supplement Fan Drive (Hydraulic) - Remove
814F Wheel Dozer, 815F Soil Compactor and 816F Landfill CompactorEngine Supplement Electronic Unit Injector - Install
RM-250C, RR-250B and RM-350B Additive Spray System Setup Procedure
CP-533C, CP-563C, CS-533C, CS-563C, CS-573C and CS-583C Paving Compactors Propel System Axle
814F Wheel Dozer, 815F Soil Compactor and 816F Landfill CompactorEngine Supplement Fuel Filter (Secondary) and Fuel Filter Base - Remove and Install - Engine in Chassis
797B Off-Highway Truck Suspension Cylinder Pressure Sensor (Payload)
814F Wheel Dozer, 815F Soil Compactor and 816F Landfill CompactorEngine Supplement Fan Drive - Disassemble
793C XQ Off-Highway Truck and 793C Off-Highway Truck Engine Supplement Fan Drive (Hydraulic) - Install
69D, 73D, 769C, 769D, 773B, 773D, 773E, 776B, 776C, 776D, 777B, 777C, 777D, 784B, 785, 785B, 789 and 793 Off-Highway Truck/Tractors and 771D, 775B, 775D and 775E Quarry Trucks Payload System Payload F02 - Suspension Cylinder (Right Front) Incorrect Charge
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.