Electronic Unit Injector - Remove
Removal Procedure
Show/hide table
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 5F-4764 | Pry Bar | 1 |
Start By:
- Remove the rocker shaft and the pushrods. Refer to Disassembly and Assembly, SENR9537, "Rocker Shaft and Pushrod - Remove".
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove plug (1) from the fuel manifold.
Show/hide table
 | |
| Illustration 1 | g00511865 |
- Drain the fuel from the cylinder head assembly into a suitable container for storage or disposal.
- Mark bridge assemblies (4) for reference during installation.
Show/hide table
 | |
| Illustration 2 | g00511868 |
- Loosen two nuts (3) and remove cap assembly (2) .
- Remove bolt (5) and spacer assembly (6) that holds the unit injector in place.
- Position Tool (A) under hold-down (8). Carefully pry unit injector (7) out of the cylinder head assembly. Remove unit injector (7) .
Show/hide table
 | |
| Illustration 3 | g00764868 |
Caterpillar Information System:
RM-250C Reclaimer Mixer and RM-350B and RR-250B Road Reclaimer/Soil Stabilizers Additive Spray System Relief Valve (Charge) - Test and Adjust
RM-250C Reclaimer Mixer and RM-350B and RR-250B Road Reclaimer/Soil Stabilizers Additive Spray System Piston Pump Flow - Test
2002/06/10 Installing a Stiffener Plate to the Lift Cylinder Tube Assemblies Increases Service Life {5057}
R1600G Load Haul Dump Steering System Solenoid Valve (Reversible Steering)
R1600G Load Haul Dump Hydraulic System Pilot Control Valve
R1600G Load Haul Dump Steering System Pressure Reducing Valve (Steering Pilot)
2002/07/15 New Flash File Software Is Used for Product Link 151/201 {7606, 7620}
3056E Industrial Engine Coolant Temperature Sensor
2002/05/27 Engine Tool Lists And Machine Tool Lists Are Available On The Caterpillar Intranet {0600}
RM-250C, RR-250B and RM-350B Additive Spray System Additive Spray System Hydraulic Filter - Replace
797B Off-Highway Truck Filter and Screen Locations
RM-250C, RR-250B and RM-350B Additive Spray System Additive Spray System Pump - Lubricate
797B Off-Highway Truck Engine Air Precleaner - Clean
793C XQ Off-Highway Truck and 793C Off-Highway Truck Engine Supplement Fan Drive (Hydraulic) - Remove
814F Wheel Dozer, 815F Soil Compactor and 816F Landfill CompactorEngine Supplement Electronic Unit Injector - Install
RM-250C, RR-250B and RM-350B Additive Spray System Setup Procedure
CP-533C, CP-563C, CS-533C, CS-563C, CS-573C and CS-583C Paving Compactors Propel System Axle
814F Wheel Dozer, 815F Soil Compactor and 816F Landfill CompactorEngine Supplement Fuel Filter (Secondary) and Fuel Filter Base - Remove and Install - Engine in Chassis
797B Off-Highway Truck Suspension Cylinder Pressure Sensor (Payload)
814F Wheel Dozer, 815F Soil Compactor and 816F Landfill CompactorEngine Supplement Fan Drive - Disassemble
793C XQ Off-Highway Truck and 793C Off-Highway Truck Engine Supplement Fan Drive (Hydraulic) - Install
69D, 73D, 769C, 769D, 773B, 773D, 773E, 776B, 776C, 776D, 777B, 777C, 777D, 784B, 785, 785B, 789 and 793 Off-Highway Truck/Tractors and 771D, 775B, 775D and 775E Quarry Trucks Payload System Payload F02 - Suspension Cylinder (Right Front) Incorrect Charge
69D, 73D, 769C, 769D, 773B, 773D, 773E, 776B, 776C, 776D, 777B, 777C, 777D, 784B, 785, 785B, 789 and 793 Off-Highway Truck/Tractors and 771D, 775B, 775D and 775E Quarry Trucks Payload System Payload F03 - Suspension Cylinder (Left Rear) Incorrect Charge
CB-434C Vibratory Compactor Safety Messages