Rotor Drive (Planetary) Oil - Change
Show/hide table
Illustration 1 | g00851046 |
- Rotate the rotor until a plug in the rotor drive is at the bottom of the rotor drive.
- Remove the drain plug. Allow the oil to drain into a suitable container. The capacity of the rotor planetary reducer is 17.8 L (4.7 US gal).
- Remove the plate from the housing for the rotor. Remove the plug.
Show/hide table
Illustration 2 | g00851059 |
- Install the drain plug after draining the oil.
- Add oil into plug hole. Fill until oil just starts to overflow the plug hole.
- After the correct oil level is ensured, install the plug and the plate.
Show/hide table
NOTICE |
---|
Do not under fill or over fill the rotor planetary reducer with oil. Either condition can cause damage to the rotor drive system. Allow enough time for oil to flow through the bearings and reach the correct level in all compartments. Allow more time for cold oil. |
Caterpillar Information System:
14H Motor Grader Transmission and Differential Oil Sample - Obtain
3024C and C1.1 Engines for Caterpillar Built Machines Troubleshooting
16H Motor Grader Wheel Lean Bearings - Lubricate
16H Motor Grader Wheel Lean Bar Bearings - Lubricate
16H Motor Grader Wheel Lean Cylinder Bearings - Lubricate
533 Wheel Feller Buncher and 543 Wheel Feller Buncher Power Train Differential
16H Motor Grader Reference Material
16H Motor Grader Steering Frame Lock
2002/02/18 A New Retaining Clip will Improve the Alignment of the Hose Assembly on the Radiator {1374, 1808, 5057, 7320}
3126 Truck Engine Military Camshaft Bearings - Install
CP-433E, CS-433E and CS433E Vibratory Soil Compactors Propel System Hydraulic Oil Filter
793C and 793C XQ Off-Highway Trucks Hydraulic System Pad Assembly (Truck Body) - Install and Adjust
994F Wheel Loader Hydraulic System Check Valve (Pilot)
C12 Marine Engine Finding Top Center Position for No. 1 Piston
Installation of New Fuel Tank on D-Series Compactors{1273} Installation of New Fuel Tank on D-Series Compactors{1273}
CB-634D Paving Compactor Cooling System Coolant Extender (ELC) - Add
533 Wheel Feller Buncher and 543 Wheel Feller Buncher Power Train Axle Housing
24H Motor Grader Ripper Control
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System General Information
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
Instructions for Installation of Oversize Hydraulic Cylinder Seals {7555, 7562} Instructions for Installation of Oversize Hydraulic Cylinder Seals {7555, 7562}
PM-465 Cold Planer Power Take-Off Clutch Oil - Change
2002/01/21 Correction to Specifications , "Transmission" {3030}
3046 Engine for Caterpillar Built Machines Turbocharger - Inspect