416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Power Train Caterpillar


Drive and Steering Axle (Rear) - Install

Usage:

416D B2D

Installation Procedure




    Illustration 1g00775630

  1. Install the sensor and bracket (28). Install 3 bolts (29) and the washers.



    Illustration 2g00775627

  1. Install pin (26) and washer (27). Install clip (25) .



    Illustration 3g00775621

  1. Install cover (23). Install 3 bolts (22) .



    Illustration 4g00775620

  1. Install bracket (21) for the parking brake.



    Illustration 5g00775608

  1. Use a suitable lifting device in order to move the axle.

    Note: The axle weighs approximately 500 kg (1102 lb).




    Illustration 6g00775593

  1. Use a hydraulic jack (19) in order to position the axle under the machine in the proper place.



    Illustration 7g00775604

  1. Install 4 nuts (20), the washers, and the plate. Repeat for the other side.

  1. Move the hydraulic jack away from the rear axle.



    Illustration 8g00775570

  1. Connect the wire for the sensor for the rear steer.

    Note: The wire is located in the area of the pointer.




    Illustration 9g00775484

  1. Install 2 hydraulic hoses (13) on the top of the axle.



    Illustration 10g00775540

  1. Install 2 hydraulic hoses (11) on rear steering cylinder (12) .



    Illustration 11g00775573

  1. Install 2 bolts (16) and pin (17) in order to install parking brake assembly (18) .



    Illustration 12g00775534

  1. Install 2 bolts (14) for bracket (15) for the manifold. Repeat for the other side of the bracket for the manifold.



    Illustration 13g00779594

  1. Install two brackets (3) for the front of the drive shaft. Install four bolts (4) for the rear of the drive shaft.

End By: Install the rear tires and wheels. See Disassembly and Assembly, "Tires & Wheels (Rear) - Remove and Install".

Caterpillar Information System:

826G Landfill Compactor, 825G Soil Compactor, 824G Wheel Dozer and 980G Wheel Loader Power Train Electronic Control System MID 081 - CID 0070 - FMI 04
Caterpillar<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> AP-900B andBarber-Greene<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> BG-240C Asphalt Pavers Hydraulic Cylinder (Tow Point) - Remove and Install
120H and 135H Motor Graders Moldboard Wear Strip - Inspect/Adjust/Replace
2001/07/09 Improved Grapple Tongs Are Used on Forwarders {6307}
826G Series II Landfill Compactor, 825G Series II Soil Compactor and 824G Series II Wheel Dozer Hydraulic System Oil Level - Check
Caterpillar<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> AP-900B andBarber-Greene<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> BG-240C Asphalt Pavers Piston Pump (Auxiliary) - Install
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Power Train Drive and Steering Axle (Rear) - Remove
12H, 140H, 143H, 160H and 163H Motor Graders Power Train Differential
Caterpillar<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> AP-900B andBarber-Greene<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> BG-240C Asphalt Pavers Piston Pump (Auxiliary) - Remove
824H Wheel Dozer, 825H Soil Compactor and 826H Landfill Compactor Fuel Tank Water and Sediment - Drain
Caterpillar<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> AP-900B andBarber-Greene<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> BG-240C Asphalt Pavers Piston Motor (Drag Conveyor) - Install
143H and 163H Motor Graders Kingpin Bearings - Lubricate
12H, 140H, 143H, 160H and 163H Motor Graders Power Train Final Drive
735 Articulated Truck Radiator Core - Clean
735 Articulated Truck Oscillating Hitch - Lubricate
2001/04/02 Correct Belt Tension is Necessary in Maintaining Service Life of V-Belt {1357, 1405, 7450}
2001/02/26 A New Shift Solenoid Increases Reliability {3174}
143H and 163H Motor Graders Wheel Lean Bar Bearings - Lubricate
2001/06/01 Guidelines For Maintenance Of Spark Plugs In Gas Engines {1555}
TH103 Telehandler Hydraulic System Telescoping Cylinder
143H and 163H Motor Graders Wheel Lean Bearings - Lubricate
143H and 163H Motor Graders Wheel Lean Cylinder Bearings - Lubricate
120H and 135H Motor Graders Window Washer Reservoir - Fill
120H and 135H Motor Graders Window Wiper - Inspect/Replace
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.