Tilt Lever - Remove
Removal Procedure
Start By:
- Remove the tilt cylinders. Refer to Disassembly and Assembly, "Tilt Cylinder - Remove".
Show/hide table
 | |
| Illustration 1 | g00285107 |
Note: The rear tilt lever is located at the rear end of the lift arms.
- Use a suitable lifting device to support tilt lever (1), as shown.
Show/hide table
 | |
| Illustration 2 | g00280357 |
- Support tilt link (2) with wood blocks, as shown.
- Remove bolt (3) and pin assembly (4) .
- Remove bolt (5) and pin assembly (6). Remove tilt lever (1). The weight of the tilt lever is approximately62 kg (135 lb).
Caterpillar Information System:
D400E Series II Ejector Truck Steering, Suspension, and Ejector Body Hydraulic Systems Manifold (Trailer)
938G Wheel Loader and IT38G Integrated Toolcarrier Machine Systems Tilt Lever (Front) and Tilt Link (Front) - Install
938G Wheel Loader and IT38G Integrated Toolcarrier Machine Systems Tilt Lever (Front) and Tilt Link (Front) - Remove
776D, 777D and 777D HAA Off-Highway Truck/Tractors Air System and Brakes Check Valve (Parking Brake Release)
CB-214D, CB-224D and CB-225D Vibratory Compactors Compaction and Rolling Procedure
TH62, TH63, TH82 and TH83 Telehandlers Tire Shipping Pressure
776D, 777D and 777D HAA Off-Highway Truck/Tractors Hydraulic System Hydraulic System
24H Motor Grader Articulation Cylinder Bearings - Lubricate
JF Series Starting Motor Field Winding - Test
2000/07/17 New Crossover Relief Valves Are Used in the Hydrostatic Pump Group {3203}
TH103 Telehandler Fuel System Primary Filter - Replace
D400E Series II Ejector Truck Steering, Suspension, and Ejector Body Hydraulic Systems Manifold (Tractor)
JF Series Starting Motor Starting Motor Does Not Turn or Turns Slowly
Alternator - Delco 27SI Brush Length - Check
938G Wheel Loader and IT38G Integrated Toolcarrier Machine Systems Tilt Lever - Install
JF Series Starting Motor Starting Motor - Disassemble
IT28G Integrated Toolcarrier and 928G Wheel Loader Brake and Fan Drive System Rocker Switch (Transmission Neutralizer Override Control)
3054B Engine for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
550, 570 and 580 Wheel Harvesters Steering Cylinder Mounting Bolts - Tighten
776D Tractors and 777D and 777D HAA Off-Highway Truck Steering System Gear Pump (Steering)
Alternator - Delco 21SI Field Winding - Test
776D, 777D and 777D HAA Off-Highway Truck/Tractors Air System and Brakes Pressure Switch (Secondary Brake and Parking Brake)
TH103 Telehandler Final Drive Oil - Change
TH103 Telehandler Final Drive Oil Level - Check