Starting Above 0°C (32°F)
Show/hide table
 |
Diesel engine exhaust contains products of combustion which may be harmful to your health Always start and operate the engine in a well-ventilated area and, if in an enclosed area, vent the exhaust to the outside. |
 |
- Move the transmission control to the NEUTRAL position. The transmission control must be in the NEUTRAL position before the engine will crank.
- Adjust the steering column tilt and telescope control. Refer to the Operation and Maintenance Manual, "Steering Column Tilt and Telescope Control".
- Move the parking and secondary brake control to the ENGAGED position. The parking and secondary brake control must be in the ENGAGED position before the engine will crank.
- Check the Caterpillar Monitoring System for correct operation. Refer to Operation and Maintenance Manual, "Caterpillar Monitoring System" .
- Turn the engine start switch key in order to start the engine. Release the engine start switch key when the engine starts.
- Operate the engine at low idle until the Caterpillar Monitoring System verifies that the engine oil pressure is normal.
Show/hide table
| NOTICE |
|---|
Do not crank the engine for more than 30 seconds. Allow the starting motor to cool for two minutes before cranking again. Turbocharger (if equipped) damage can result, if the engine rpm is not kept low until the engine oil light/gauge verifies the oil pressure is sufficient. |
Caterpillar Information System:
D400E Series II Ejector Truck Cold Weather Operation
D400E Series II Ejector Truck After Starting Engine
Caterpillar<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> AP-900B andBarber-Greene<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> BG-240C Asphalt Pavers Propel System Front Wheel Drive Manifold
Caterpillar<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> AP-900B andBarber-Greene<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> BG-240C Asphalt Pavers Propel System General Information
2000/03/27 Maintenance and Repair to a Closed Loop System for the Engine Crankcase Breather {1107, 1317}
2000/03/20 A New Indicator Assembly (Voltmeter) {7450}
776D, 777D and 777D HAA Off-Highway Truck/Tractors Air System and Brakes Gear Pump (Pulled Unit)
3618 Engine Main Bearings
776D, 777D and 777D HAA Off-Highway Truck/Tractors Air System and Brakes Gear Pump (Hoist)
2000/05/01 A Guard for the Transmission Breather Can Be Installed {7153}
2000/03/27 Dimensions in Special Instruction are now Updated {3260, 3269, 6116, 6118, 6119, 6125, 6126, 6127, 7057, 7069, 7100}
776D, 777D and 777D HAA Off-Highway Truck/Tractors Air System and Brakes Gear Pump (Torque Converter Charging, Scavenge, and Brake Release)
D400E Series II Ejector Truck Loading
D400E Series II Ejector Truck Machine Operation Information
D400E Series II Ejector Truck Towing the Machine
D400E Series II Ejector Truck Machine Parking
D400E Series II Ejector Truck Engine Starting
D400E Series II Ejector Truck General Hazard Information
D400E Series II Ejector Truck Shipping the Machine
D400E Series II Ejector Truck Tailgate
D400E Series II Ejector Truck Lifting and Tying Down the Machine
797 Off-Highway Truck Power Train Differential and Bevel Gear - Assemble
776D, 777D and 777D HAA Off-Highway Truck/Tractors Air System and Brakes Relief Valve (Brake Oil Cooler)
776D, 777D and 777D HAA Off-Highway Truck/Tractors Air System and Brakes Relief Valve (Brake Oil Cooler)