572R Pipelayer Power Train Caterpillar

Installation Procedure

Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.

Show/hide table



Illustration 1	g00649932

Show/hide table



Illustration 2	g00649931

1. Install two bolts (22) on oil filter (11) and Tooling (A). Attach a strap and a suitable lifting device to the oil filter. Position the oil filter back to the original location.

2. Install four bolts (23) and the washers on bracket (24) .

Show/hide table



Illustration 3	g00649929

3. Install bolt (19) on clip (20) on the bottom of oil filter (11). Install nut (20) and the two washers.

Show/hide table



Illustration 4	g00649928

4. Install the O-ring seal on hose assembly (17). Connect hose assembly (17) on oil filter (11). Install four bolts (16), the four washers, and two half flanges (15). Install the O-ring seal on hose assembly (18). Connect hose assembly (18) on oil filter (11). Install four bolts (13), the four washers, and two half flanges (12). Install two nuts (10) and connect wires (9) on sending unit (14).

Show/hide table



Illustration 5	g00649927

5. Install cover (5). Install bolt (7), the washer, and bracket (8) .

Show/hide table



Illustration 6	g00649926

6. Install bolt (4), the two washers,and the nut. Install bolt (6) and the washer. Turn handle (1), and close cover (2). Install padlock (3) .