Air Pressure Gauge - Test
Show/hide table
为避免人员伤害,在卸下测试仪表和软管总成之前,确保气罐内的气压已全部排尽。 |
Show/hide table
所需工具     | |||
工具     | 零件号     | 描述     | 数量     |
A     | 3B-7722     | 管衬套     | 3     |
B     | 6V-3966     | 接头组件     | 3     |
C     | 6V-4143     | 快速连接连接器     | 3     |
D     | 8T-0849     | 压力表     | 3     |
E     | 6V-4055     | 压力软管组件     | 3     |
- 打开排放阀 (2) 、 (3) 及 (5) ,卸下气罐内的气压。
- 将工具 (A) 和工具 (B) 安装在各排放阀的开口处。
Show/hide table
图 1 | g01351918 |
排放阀。 (1) 气罐。 (3) 左方气罐的排放阀。 (2) 右方气罐的排放阀。 |
Show/hide table
图 2 | g01351926 |
欧洲行车配置的气罐。 (4) 气罐。 (5) 排放阀。 |
- 将工具 (C) 安装在工具 (D) 上,连接工具 (E) 和气罐,以及测试压力表。
- 起动发动机,使气压增加到最大压力。
- 把机器上的压力表与已知精确度的测试用压力表进行比较。
- 仪表板左侧的气压表是用于左边的气罐 (1) 。 仪表板右侧的气压表是用于右边的气罐 (1) 。 如果机器的配置是按照欧洲行车配置标准,则仪表板上左侧的气压表是用于气罐 (4) 。 仪表板上右侧的气压表是用于气罐 (2) 。
Show/hide table
图 3 | g00107676 |
空气压力表(典型示例) |
- 如果机器仪表板上的气压表与测试用气压表比较产生的误差超过 35 kPa (5 psi),装上新的气压表。
Caterpillar Information System:
776D and 777D Off-Highway Truck/Tractors Hydraulic System Proportioning Solenoid (Hoist) - Test
3500B Engines for 776D, 777D, 784C, 785C, 789C and 793C Off-Highway Trucks Boost Pressure Above Normal
C9 Engine For Caterpillar Built Machines Belt Tensioner - Remove and Install
776D, 777D and 777D HAA Off-Highway Truck/Tractors Hydraulic System Pad Assembly (Truck Body) - Install and Adjust
D350E Series II and D400E Series II Articulated Trucks Cooling System Coolant (ELC) - Change
C9 Engine For Caterpillar Built Machines Engine Oil Cooler - Install
3500B Engines for 776D, 777D, 784C, 785C, 789C and 793C Off-Highway Trucks Boost Pressure Below Normal
416C, 426C, 428C, 436C and 438C Backhoe Loaders Extendable Stick Pads - Inspect/Replace - If Equipped
C9 Engine For Caterpillar Built Machines Engine Oil Cooler - Remove
12H, 140H and 160H Motor Graders Machine Systems Metering Pump (Steering) - Assemble
3500B Engines for 776D, 777D, 784C, 785C, 789C and 793C Off-Highway Trucks Engine Speed/Timing Sensor
3056 Engine for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
3500B Engines for 776D, 777D, 784C, 785C, 789C and 793C Off-Highway Trucks Analog Sensor - Calibrate
AP-1055B and BG-2455C Asphalt Pavers Propel System General Information
AP-1055B and BG-2455C Asphalt Pavers Propel System Propel Hydraulic System
AP-1055B and BG-2455C Asphalt Pavers Propel System Piston Pump (Propel)
D250E Series II and D300E Series II Articulated Trucks Steering, Suspension, and Body Hoist Hydraulic Systems Relief Valve (Hoist Lower) - Test and Adjust
AP-1055B and BG-2455C Asphalt Pavers Propel System Piston Motor (Propel)
AP-1055B and BG-2455C Asphalt Pavers Propel System Final Drive Planetary
AP-1055B and BG-2455C Asphalt Pavers Propel System Parking Brake
120H, 12H, 135H, 140H, 143H, 160H and 163H Motor Graders Air System and Brakes Air Compressor Governor - Test and Adjust
776D and 777D Off-Highway Truck/Tractors Hydraulic System Hoist Cylinder Performance - Test
3176C and 3196 Industrial Engines Air Compressor Drive Gear - Remove
416C, 426C, 428C, 436C and 438C Backhoe Loaders Installation of Bucket Stop - If Equipped