This is the procedure for inspecting the charge spool. The charge spool is located in the all wheel drive control valve. If the charge spool is worn or sticking, the following conditions may occur.
- The all wheel drive piston motors may not engage.
- The all wheel drive piston motors may clack too much during engagement.
Reference: Refer to Troubleshooting, "All Wheel Drive Control Valve".
Test Step 1. Perform the following test: Machine Preparation for Troubleshooting
Results:
- OK - Proceed to test step 2.
Test Step 2. Perform the following test: Hydraulic Pressure - Release
Results:
- OK - Proceed to test step 3.
Test Step 3.
- Remove plug (2), spring (3), spring (4) and charge spool (5) from all wheel drive control valve (1) .
Personal injury can result from being struck by parts propelled by a released spring force. Make sure to wear all necessary protective equipment. Follow the recommended procedure and use all recommended tooling to release the spring force. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Inspect spring (3), spring (4) and charge spool (5) for wear or damage.
Illustration 1 | g00557670 |
CHARGE SPOOL |
Reference: Refer to Troubleshooting, "All Wheel Drive Control Valve".System Operation
Reference: Refer to Troubleshooting, "All Wheel Drive Control Valve".
Expected Result:
The springs and the charge spool are in good condition.
Results:
- No - Proceed to test step 4.
- Yes - Proceed to test step 5.
Test Step 4.
- Replace the worn parts or the damaged parts. If the charge spool is worn or damaged, the all wheel drive control valve must be replaced. Use a new Caterpillar part for replacement.
- Clean all parts prior to installation in all wheel drive control valve (1). Install charge spool (5), spring (4), spring (3) and plug (2) to all wheel drive control valve (1).
Reference: Refer to Troubleshooting, "All Wheel Drive Control Valve".Specifications
Reference: Refer to Troubleshooting, "All Wheel Drive Control Valve".Parts
Reference: Refer to Troubleshooting, "8X-2518 LINES GP-MOTOR-AWD PIN 5AK1-UP. PART OF 8W-6310 DRIVE AR-ALL WHEEL".Photo
Illustration 2 | g00557670 |
CHARGE SPOOL |
Expected Result:
The worn parts or the damaged parts have been replaced.
Results:
- Repair Complete - Stop.
Test Step 5.
- Clean all parts prior to installation in all wheel drive control valve (1). Install charge spool (5), spring (4), spring (3) and plug (2) to all wheel drive control valve (1).
Reference: Refer to Troubleshooting, "All Wheel Drive Control Valve".Specifications
Reference: Refer to Troubleshooting, "All Wheel Drive Control Valve".Photo
Illustration 3 | g00557670 |
CHARGE SPOOL |
Expected Result:
The parts have been installed in the all wheel drive control valve.
Results:
- OK - Stop.