Removal Procedure
Start By:
- Remove the battery box. Refer to Disassembly and Assembly, "Battery Box - Remove and Install" for the machine that is being serviced.
- Remove the right side covers. Refer to Disassembly and Assembly, "Covers - Remove and Install".
Note: The right side undercarriage has been removed for photographic reasons.
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
 |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
 |
- Remove two hose assemblies (2) from steering motor (1) .
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
 | |
| Illustration 1 | g00700452 |
- Disconnect tube assembly (3) from steering motor (1) .
 | |
| Illustration 2 | g00700456 |
Note: The implement valve has been removed for photographic reasons.
- Attach a lifting strap to a hoist and steering motor (1), as shown.
 | |
| Illustration 3 | g00700458 |
- Remove four socket head bolts and washers (4) from steering motor (1) .
- Remove steering motor (1) from top cover (5). Check O-ring (6). If necessary, replace O-ring (6). The weight of the steering motor is 34 kg (75.0 lb).
 | |
| Illustration 4 | g00700459 |