 | |
| Illustration 1 | g00434679 |
(1) Torque for 22 bolts ... 430 ± 60 N·m (317 ± 44 lb ft)
(2) Rubber toric seals must be clean and dry at assembly. All surfaces that contact the toric seals must be clean and dry at assembly. At assembly, apply a thin film of oil to the contacting surfaces of the metal seal. Seal rings must be assembled squarely with the bore. The toric ring must not bulge and the toric ring must not be twisted. Refer to 6Y-0300 Installation Instructions for Conventional Duo-Cone Seal Assemblies .
(3) Torque for bolts ... 135 ± 20 N·m (100 ± 15 lb ft)
Note: Be sure that there is metal to metal contact between the retainer and the spindle before the bolts are tightened.
(4) Torque for 28 bolts ... 240 ± 40 N·m (177 ± 30 lb ft)
(5) Dimension from the spindle to the bearing cone ... 25.16 ± 0.05 mm (0.991 ± 0.002 inch)
(6) Put 2P-2506 Thread Compound on the threads of the sprocket bolts. First, tighten the sprocket bolts to the following torque. ... 175 ± 40 N·m (130 ± 30 lb ft)
Then, tighten the sprocket bolts by an additional 1/3 turn.
Minimum torque after the additional 1/3 turn ... 380 N·m (280 lb ft)