Removal Procedure
Start By:
- Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
- Release the pressure in the hydraulic system. Refer to Disassembly and Assembly, "System Pressure - Release".
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
Note: Put identification marks on all lines and on all hoses. Plug all lines and all hoses. This will help to prevent fluid loss and this will help to keep contaminants from entering the system.
- Disconnect hydraulic hose assembly (1) from the rod end of steering cylinder (2) .
Illustration 1 | g00357417 |
- Remove three hose brackets (3) from steering cylinder (2) .
Illustration 2 | g00357418 |
- Remove two bolts (4). Place manifold block (5) aside.
Illustration 3 | g00357419 |
- Disconnect hydraulic hose assembly (6) from the rod end of steering cylinder (2) .
- Disconnect grease line (7) .
Illustration 4 | g00357421 |
- Remove bolt (8), the washer, and pin (9) from the rod end of steering cylinder (2) .
- Remove bolt (10), the washer, and pin (11) from the rod end of steering cylinder (2) .
Illustration 5 | g00357422 |
- Use two people to remove steering cylinder (2). The weight of the steering cylinder is 34 kg (75 lb).