O-Ring Missing On Pressure Switch Caterpillar


O-Ring Missing On Pressure Switch

Usage:

SKID STEER LOADERS246 (5SZ1-289, 5SZ292-339, 5SZ341-344, 5SZ346, 5SZ348-361, 5SZ364-365, 5SZ370, 5SZ374) SKID STEER LOADERS

Problem:

The 3J-1907 O-Ring Seal may be missing on the 173-3837 Pressure Switch in the 173-3038 Hydraulic Filter Lines, which may cause a hydraulic oil leak over a period of time.

Solution:

Install the 3J-1907 O-Ring Seal on the pressure switch. This part is not shown in the Parts Manual.

Installation Procedure

1. Disconnect the electrical connector plug from the 173-3837 Pressure Switch.
2. Disconnect the electrical connector plug from the 173-3837 Pressure Switch.
3. Install the 3J-1907 O-Ring Seal on the 173-3837 Pressure Switch. Install the pressure switch. Tighten the pressure switch to a torque of 24 ± 3 N·m.
4. Reconnect the electrical connector plug on the pressure switch.
5. Check for leaks.

COPYRIGHT 1999 CATERPILLAR ALL RIGHTS RESERVED

Caterpillar Information System:

7N-5946 Pressure Switch (Engine) is replaced by 162-0782 Presure Switch (Engine) on Asphalt Pavers 7N-5946 Pressure Switch (Engine) is replaced by 162-0782 Presure Switch (Engine) on Asphalt Pavers
Six Bolt And Ten Bolt Whel Hubs On The Rear Steering Axles Require Aditional Grease Six Bolt And Ten Bolt Whel Hubs On The Rear Steering Axles Require Aditional Grease
BG-210B Axle Interference BG-210B Axle Interference
Auger Chain Housing Wear Auger Chain Housing Wear
Failures Of The 147-1773 Circuit Breaker Failures Of The 147-1773 Circuit Breaker
Screed Endgate May Hang-Up During Operation Screed Endgate May Hang-Up During Operation
112-7087 Seal May Be The Wrong Lip Type Seal 112-7087 Seal May Be The Wrong Lip Type Seal
136-4524, 136-4523 Planetary Drives For The Ground Drive System 136-4524, 136-4523 Planetary Drives For The Ground Drive System
Improperly Torqued Hardware On Muffler Group Improperly Torqued Hardware On Muffler Group
Lock Valve Leaking Causing Implement Drift Or Undesired Machine Lock Valve Leaking Causing Implement Drift Or Undesired Machine
Remanufactured Water Pump For 3500 Engine Remanufactured Water Pump For 3500 Engine
Clarification Of Service Letter PI3136 Clarification Of Service Letter PI3136
Water In Hydraulic Oil Water In Hydraulic Oil
Possible Problems WIth Dash Lighting On 769 Through 775 Off-Highway Trucks That Have Been Field Equipped With LED Lamps Possible Problems WIth Dash Lighting On 769 Through 775 Off-Highway Trucks That Have Been Field Equipped With LED Lamps
Brake Life Severely Reduced When Performing Production Compaction Cycles In Travel (Third) Speed Brake Life Severely Reduced When Performing Production Compaction Cycles In Travel (Third) Speed
Longitudinal Stability Indicator Display Has An Improved Capacitor (If Equipped) Longitudinal Stability Indicator Display Has An Improved Capacitor (If Equipped)
Possible Oil Leaks From Steering Metering Pump Possible Oil Leaks From Steering Metering Pump
Articulation Gauge Requires Time To Warm Up Prior To Making Any Adjustments Articulation Gauge Requires Time To Warm Up Prior To Making Any Adjustments
Valve Spring Failures On 3100 Engines Produced By Shin Caterpillar Mitsubishi (SCM) At Sagami Valve Spring Failures On 3100 Engines Produced By Shin Caterpillar Mitsubishi (SCM) At Sagami
Tattletale Mode 4 Indicates Ground Speed After The Caterpillar Monitoring System Has Been Cleared, And Without The Machine Moving Tattletale Mode 4 Indicates Ground Speed After The Caterpillar Monitoring System Has Been Cleared, And Without The Machine Moving
Additional Counterweight Additional Counterweight
793C Gear Pump Group May Have Lip Seals Improperly Installed 793C Gear Pump Group May Have Lip Seals Improperly Installed
Service Door Latch On Engine Hood Service Door Latch On Engine Hood
Twisted Or Kinked Fuel Line May Cause Intermittent Engine Stalling Twisted Or Kinked Fuel Line May Cause Intermittent Engine Stalling
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.