Modifications To Body Guide Prevent Interference {7258}
Usage:
D400D (8TF1141-Up) Articulated Trucks
The following article describes how to modify the 7U-7660 Body Guide Assembly. The left hand 7U-7660 Body Guide Assembly can contact the air tank on the left hand side of the rear chassis, in some applications. The following illustration identifies the area to be removed from the guide to prevent any contact.
End View of 7U-7660 Body Guide Assembly (A) Center of tangent. (B) Shaded portion to be removed. (C) 17.5 mm (.69 in)
Caterpillar Information System:
1996/10/28 New Race Used in Steering Groups to Improve Angular Rotation of Sockets {4305}
1996/10/28 Parts Added to Increase Clearance Between Steering Relief Valve Group and Engine Oil Pan Assembly {4304,4307}
1996/10/28 Higher Viscosity Power Train Oil Should Be Used in Certain Applications {4070,0645}
1996/10/28 New Flange And Seal Can Be Used In Engine Turbocharger Groups To Help Prevent Exhaust Leaks {1052,1059}
1996/10/28 Cab Door Hold Back Latch Modifications Improve Door Retention {7308,7325}
1996/10/28 Front Idler Hub Oil Change Interval And Factory Oil Fill Changed {4159,4167,4215}
1996/10/28 Improved Final Drive Pinion Bearing Setting Procedure Used And New Shim Pack Kit Available {4050,4091}
1996/10/21 New O-Ring Seals Used On "Through-Head-Adapter" And "Internal Fuel Lines" In Fuel Injection Lines Groups{1252}
1996/10/21 Proper Procedure For Servicing And Cleaning The Fuel Injection Pump{1251}
1996/10/21 Be Sure To Use Correct Length Retaining Bolts For Boom Wear Pads{6460}
1996/10/21 Rolling Hose Pulley Modification Improves Hose Retention{6460}
1996/10/21 Pivot Pin Is Now Serviceable In Rotate Fork Carriage Groups {6400,6408}
1996/10/28 Special Instruction SEHS9952 Available for Procedure to Repair Dump Body Pivot Assemblies {7258}
1996/10/28 Special Instruction SEHS9953 Available for Procedure to Repair Dump Body Pivot Assemblies {7258}
1996/10/28 Procedure To Adjust Creeper Speed Control {3162}
1996/10/28 Additional Brake System Servicing Information {4005}
1996/10/28 Boom And Attachment Control Must Be In The "HOLD" Position When Starting The Engine {5725,7400}
1996/10/28 Procedure To Assemble Hydraulic Pilot Line Fittings {5057}
1996/10/28 Seal Kits For Hydraulic Unit Injector Pump Groups Available {1250,1714}
1996/10/28 New Procedure For Installing The Gear On Scavenge Oil Pump Shafts Within Scavenge Oil Pump Groups {1312}
1996/11/04 New Tooling Available To Install Power Take-off Output Shaft And Hitch Rock Shaft Seals {0745,3107,0755,7117}
1996/11/04 Improper Monitoring Of DIFFERENTIAL OIL LEVEL By Vital Information Management System (VIMS) {3258,1920,7601}
1996/11/04 New Suspension Frame Group Now Used To Prevent Cracking {7216,7203}
1996/11/04 Adjustment Procedure For Cab Door Latch And Hold-Open Release {7301,7308}