Usage:
1. Lift the hoods, and fasten them in position with the hood locks.
2. Disconnect hose (1) at governor control cylinder (2).
3. Remove pin (4).
4. Remove governor control cylinder (2).
5. Note the position of linkage (3) in the lever, and remove linkage (3).
NOTE: The following steps are for installation of the governor control cylinder.
6. Adjust linkage (3) so the distance between rod end centers is 84.07 mm (3.309 in.).
7. Install linkage (3) in its original position in the lever.
8. Be sure lever (5) on the governor shaft is at 15° from vertical (CW when viewed from the left side of the machine) with engine at low idle.
9. Install control cylinder (2). Install pin (4) through link (3) and lever (5).
10. Connect hose (1) to governor control cylinder (2).
11. Adjust linkage (3) so lever (5) is at low idle when governor control cylinder is fully retracted.
12. Lower the hoods.
END BY:
a. remove body support (FT1437) or body retaining pins
Disassemble And Assembly Governor Control Cylinder
START BY:
a. remove governor control cylinder
1. Remove cover (1).
 |
A spring force of 44.5 N (10 lb.) will be released when the bolt that holds piston (8) is removed. Hold the components of the governor control cylinder to prevent unexpected movement of components and personal injury. |
 |
2. Remove the bolt that holds piston (6), and remove the piston and springs.
3. Remove O-ring seal (2) and sleeve (5).
4. Remove seals (3) and (4) from piston (6).
NOTE: The following steps are for the assembly of the governor control cylinder.
5. Install lip-type seal (3) and "T" seal on the piston (6). Install the lip-type seal with the lip facing the cylinder pressure source.
6. Install shell (5) in the air chamber body.
7. Put 5P960 Multipurpose Grease inside the shell.
8. Carefully install piston (6) and springs into the air chamber body.
9. Install the bolt to hold the piston.
10. Install O-ring seal (2) and cover (1).
END BY:
a. install governor control cylinder