Usage:
Start By:
a. remove main drive shaft
b. remove implement pump
1. Remove floor plate (1).
2. Remove the inspection plate at the bottom of the torque converter, and install Tooling (A).
3. Raise the tractor to a height of 914.4 mm (36 in) between the floor and the side step going in the cab.
4. Install Tooling (B) under rear slide frame (2).
5. Install Tooling (C) under front axle (3).
6. Remove plug (4) and drain the transmission oil in a suitable container.
7. Remove four bolts (5), that secure the motor mounts to the transmission. Do this process on both sides. Remove two bolts (6) that holds the oil filler tube.
8. Position Tooling (D) under transmission (7). Bolt Tooling (E) to each side of transmission (7) to maintain a good balance.
9. Mark and disconnect all wiring harnesses on top of the transmission and lower the transmission from the machine.
10. Remove 14 bolts (8).
11. Use leveling screws (9) to balance the transmission.
NOTE: Install in the transmission in the reverse order.
End By:
a. install implement pump
b. install main drive shaft