301.5, 301.6, 301.7 CR, 301.8, and 302 CR Mini Hydraulic Excavator Machine System Caterpillar


Main Hydraulic Pump Air - Purge

Usage:

301.8 H8X
完成主泵维修或液压油更换后,请排除液压系统中的空气。 按照下述方式清除空气:


注意

在检查、保养、测试、调整及维修产品时,请小心确保盛接油液。 在打开任何舱室或拆卸任何含有油液的部件前,请准备好盛接液体用的适当容器。

有关收集和盛接 Cat® 产品的油液的合适工具和用品,请参考专门出版物, NENG2500, "代理商维修工具目录"。

按照本地法规和要求处置所有油液。


------ WARNING! ------

滚热的油或液压油的压力会对人员造成伤害。

发动机停机之后,液压油的压力仍会保留在液压系统里。 对液压系统进行维修之前,如果不事先释放压力,可能会造成严重伤害。

卸下液压系统的部件或管路时,确保所有的作业机具都已降到地面上,而且液压油温度已冷。 只能在发动机停机,并且加注口盖冷却到可以用徒手触摸时才能卸下加注口盖。




    图 1g06277988
    主液压泵
    (1) 排流口

  1. 松开主液压泵上的排放口 (1)。

  2. 起动发动机以低怠速运转。

    注: 在此阶段,不要操作机器。

  3. 当系统中不再有残余空气时,排气完成。

Caterpillar Information System:

PVT110, PVT115 4V3 and PVT117 4V3 Photovoltaic Modules Electrical Connections - Check
C9 Generator Set Generator Bearing - Inspect
C18 Generator Sets Generator - Dry
New Rotary Switch is Now Used for MECP1 Panel on Certain Engines {7451} New Rotary Switch is Now Used for MECP1 Panel on Certain Engines {7451}
307.5, 308, 308.5, 309, and 310 Mini Hydraulic Excavators Air Conditioning and Heating Control
307.5, 308, 308.5, 309, and 310 Mini Hydraulic Excavators Radio
Shutdowns May Occur with NOx Sensor Diagnostic Codes Present on Certain CG137, G3400, G3500, and G3600 Gas Engines {191N, 7432} Shutdowns May Occur with NOx Sensor Diagnostic Codes Present on Certain CG137, G3400, G3500, and G3600 Gas Engines {191N, 7432}
307.5, 308, 308.5, 309, and 310 Mini Hydraulic Excavators Fuel Transfer Pump (Refueling) - If Equipped
C9.3B Engines for Caterpillar Built Machines Diesel Exhaust Fluid Module - Disassemble
SCR Retrofit Aftertreatment Kit Catalyst (SCR) - Remove and Install
307.5, 308, 308.5, 309, and 310 Mini Hydraulic Excavators Monitoring System
307.5, 308, 308.5, 309, and 310 Mini Hydraulic Excavators Camera - If Equipped
C18 Generator Sets Single Unit Operation
301.5, 301.6, 301.7 CR, 301.8, and 302 CR Mini Hydraulic Excavator Machine System Engine Performance - Test - Engine Speed
307.5, 308, 308.5, 309, and 310 Mini Hydraulic Excavators Mirror
301.5, 301.6, 301.7 CR, 301.8, and 302 CR Mini Hydraulic Excavator Machine System Travel on Level Ground - Test
PVT110, PVT115 4V3 and PVT117 4V3 Photovoltaic Modules Module - Clean
PM820, PM822, and PM825 Cold Planer Machine Systems Rotor Drive Planetary - Remove and Install
C18 Generator Sets Generator Lead Connections
301.5, 301.6, 301.7 CR, 301.8, and 302 CR Mini Hydraulic Excavator Machine System Travel on Level Ground - Test - Optional Test
301.5, 301.6, 301.7 CR, 301.8, and 302 CR Mini Hydraulic Excavator Machine System Machine Drift on a Slope - Check
Reuse And Salvage Has Updated Air Inlet Correction Factors for Dynamometer Testing {0769, 1052, 1087} Reuse And Salvage Has Updated Air Inlet Correction Factors for Dynamometer Testing {0769, 1052, 1087}
Reuse And Salvage Has Updated Air Inlet Correction Factors for Dynamometer Testing {1000, 1052, 1087} Reuse And Salvage Has Updated Air Inlet Correction Factors for Dynamometer Testing {1000, 1052, 1087}
PVT110, PVT115 4V3 and PVT117 4V3 Photovoltaic Modules Safety
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.