C7.1 Engines and Generator Sets Caterpillar


ECM Will Not Accept Factory Passwords

Usage:

C7.1 770

Probable Causes

One of the following items may not be recorded correctly on the electronic service tool:

  • Passwords

  • Serial numbers

  • Total tattletale

  • Reason code

Recommended Actions

  1. Verify that the correct passwords were entered. Check every character in each password. Remove the electrical power from the engine for 30 seconds and then retry.

  2. Verify that the electronic service tool is displaying the "Enter Factory Passwords" dialog box.

  3. Use the electronic service tool to verify that the following information has been entered correctly:

    • Engine serial number

    • Serial number for the electronic control module

    • Serial number for the electronic service tool

    • Total tattletale

    • Reason code

For additional information, refer to Troubleshooting, "Factory Passwords".

Caterpillar Information System:

C7.1 Engines and Generator Sets Factory Passwords
C7.1 Engines and Generator Sets Customer Passwords
C9.3B Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
G3516 Petroleum Engine Manual Stop Procedure
G3516 Petroleum Engine Engine Operation
3512E and 3516E Marine Engines Pistons and Connecting Rods - Install
G3516 Petroleum Engine After Starting Engine
G3516 Petroleum Engine Starting the Engine
C7.1 Engines and Generator Sets Water in Fuel - Test
G3516 Petroleum Engine Cold Weather Starting
Installation of G610 Hardware for Cat® Terrain v6.0 for Excavators {7490} Installation of G610 Hardware for Cat® Terrain v6.0 for Excavators {7490}
C7.1 Engines and Generator Sets Valve Position - Test
C7.1 Engines and Generator Sets Electronic Service Tool Does Not Communicate
C7.1 Engines and Generator Sets Codes that Inhibit Operation of Aftertreatment System
C7.1 Engines and Generator Sets Test ECM Mode
C7.1 Engines and Generator Sets Injector Code - Calibrate
C7.1 Engines and Generator Sets ECM Software - Install
C7.1 Engines and Generator Sets ECM - Replace
C7.1 Engines and Generator Sets Electrical Connectors - Inspect
C7.1 Engines and Generator Sets Cooling Fan - Calibrate
3516E Engines for 793D Off-Highway Trucks Turbocharger Turbine Temperature Is High
C3.3B and C3.8 Engines for Caterpillar Built Machines Solenoid Valve - Test - Solenoid Valves that Connect to the Dosing Control Unit (DCU)
C3.3B and C3.8 Engines for Caterpillar Built Machines Solenoid Valve - Test - Pressure Relief Valve
G3516 Petroleum Engine Engine Oil and Filter - Change
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.