C3.3B and C3.8 Engines for Caterpillar Built Machines Caterpillar


Solenoid Valve - Test - Solenoid Valves that Connect to the Dosing Control Unit (DCU)

Usage:

299D3XHP AN9
注: 本步骤涉及以下故障诊断代码:

表 1
电磁阀诊断代码 
J1939 代码和描述  代码的前提条件  注释 
3363-3
后处理 #1 DEF 罐加热器:电压高于正常值 
蓄电池电压正常

- 钥匙开关信号(ECM:V13 和 V33,DCU:18 端子)持续激活超过 2 秒

- 除起动马达停止后 2 秒外,起动马达开关信号(ECM:V12 端子)未处于激活状态

- DCU 和发动机 ECM 之间的 CAN 通信正常

- 在 DCU 通电后 160 秒内未完成诊断 
线束的 +B 短路

冷却液阀线圈的 +B 短路

当高压侧开关断开时,冷却液阀端子监视电压 (1) 为 1.937 V 或以上(仅在 DCU 电源接通后)持续至少 80 秒。

停止冷却液阀 
3363-4
后处理 #1 DEF 罐加热器:电压低于正常值 
线束对接地短路或开路

冷却液阀线圈对接地短路或开路

当高压侧开关接通时,冷却液阀端子监视电压 (*1) 为 0.503 V 或以下。 (仅在 DCU 电源接通后)持续至少 80 秒

停止冷却液阀
3363-5
后处理 #1 DEF 罐加热器:电流低于正常值 
线束开路

冷却液阀加热器线圈开路

当高压侧开关接通时,冷却液阀端子监视电压 (1) 为 0.503 V 或以上以及 1.937 V 或以下。 (仅在 DCU 电源接通后)持续至少 80 秒

停止冷却液阀

Caterpillar Information System:

3516E Engines for 793D Off-Highway Trucks Turbocharger Turbine Temperature Is High
C7.1 Engines and Generator Sets Cooling Fan - Calibrate
C7.1 Engines and Generator Sets Electrical Connectors - Inspect
C7.1 Engines and Generator Sets ECM - Replace
C7.1 Engines and Generator Sets ECM Software - Install
C7.1 Engines and Generator Sets Injector Code - Calibrate
C7.1 Engines and Generator Sets Test ECM Mode
C7.1 Engines and Generator Sets Codes that Inhibit Operation of Aftertreatment System
C7.1 Engines and Generator Sets Electronic Service Tool Does Not Communicate
C7.1 Engines and Generator Sets ECM Will Not Accept Factory Passwords
C7.1 Engines and Generator Sets Factory Passwords
C7.1 Engines and Generator Sets Customer Passwords
C3.3B and C3.8 Engines for Caterpillar Built Machines Solenoid Valve - Test - Pressure Relief Valve
G3516 Petroleum Engine Engine Oil and Filter - Change
A New Stub Shaft Is Available for 3500 Commercial Engines {1359} A New Stub Shaft Is Available for 3500 Commercial Engines {1359}
C175 Tier 4 Final Engines for Caterpillar Built Machines Pressure Sensor (Exhaust Inlet) - Remove and Install
C9 Generator Set Engines CID 0001 FMI 05 Cylinder #1 Injector open circuit
C9 Generator Set Engines CID 0001 FMI 06 Cylinder #1 Injector short
C9 Generator Set Engines CID 0002 FMI 05 Cylinder #2 Injector open circuit
C9 Generator Set Engines CID 0002 FMI 06 Cylinder #2 Injector short
C9 Generator Set Engines CID 0003 FMI 05 Cylinder #3 Injector open circuit
C9 Generator Set Engines CID 0003 FMI 06 Cylinder #3 Injector short
C9 Generator Set Engines CID 0004 FMI 05 Cylinder #4 Injector open circuit
C9 Generator Set Engines CID 0004 FMI 06 Cylinder #4 Injector short
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.