| |
| Illustration 1 | g06043789 |
|
Output Transfer Gears (1) Case (2) Drive gear (3) Shims (4) Driven gear (5) Shaft (6) Output Flange Assembly (7) Output Flange Assembly | |
The output transfer gears are at the output side of the transmission. The transmission output shaft is connected to drive gear (2) by splines.
Drive gear (2) is engaged with driven gear (4). Driven gear (4) is connected to shaft (5) by splines. Output Flange Assemblies (6) and (7) are connected to shaft (5) by splines.
The flow of power in the output transfer gears goes from the transmission output shaft to drive gear (2). The power then flows from drive gear (2) to driven gear (4). The power then flows from the driven gear to shaft (5).
Shims (3) are used to adjust the end play of gear (2).
| |
| Illustration 2 | g02425336 |
|
Magnetic Screen Assembly (1) Magnetic tube (2) Screen (3) Seal | |
The magnetic screen assembly is located on the lower portion of the output transfer gear case. Oil from the bottom of the transfer gear case flows through an inlet passage. As the oil flows through the screen, foreign particles that are in the oil are stopped by the screen. The screen keeps the foreign particles from going into the transmission hydraulic system.
As the oil flows through the screen, the oil flows over the magnets. The magnets are installed on the tube assembly so that the magnetic are close to each other. Small metal particles that may go through the screen are pulled to the magnets. The magnets retain metal particles in order to prevent metal in the transmission hydraulic system. Oil then flows to the transmission pump.