Rocker Arm - Remove
开始:
- 拆下阀室盖。
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 从摇臂轴上卸下两个螺栓 (4) 和垫圈。
- 在所有组件上做上识别标记，以便于组装。
- 从摇臂轴的一端卸下两个螺栓 (3) 和盘 (2)。
- 从摇臂轴 (5) 上拆下下列摇臂： (6)、 (7) 和 (8)。
注: 使用 O 形密封圈将按钮 (1) 固定在摇臂上。
- 从摇臂上卸下按钮 (1) 和 O 形密封圈。
Show/hide table
| |
| 图 1 | g03831463 |
Show/hide table
| |
| 图 2 | g00563304 |
注: 图片未显示此步骤中从缸盖上卸下的摇臂组件。
Caterpillar Information System:
C11, C13, C15, and C18 Industrial Engines Exhaust Balance Valve - Test
G3612 and G3616 Engines Valve Cover Base - Remove and Install
Tier 4 Final Engines for Wheel Tractor-Scrapers Data Link - Test
C18 Industrial Engine Fuel Pressure Is Low
C9.3 Marine Auxiliary and Generator Set Engine Sensor Signal (Analog, Passive) - Test
C11, C13, C15, and C18 Industrial Engines Cooling Fan Control - Test
C175-16 Engine for Off-Highway Trucks Engine Oil Level Sensor
C2.2 Engines For Caterpillar Built Machines Data Link Configuration Status - Test
Procedure to Upgrade EMCP 1, EMCP 2, EMCP 2+, EMCP 3.1, EMCP 3.2, and EMCP 3.3 to EMCP 4.2 {4490, 7451} Procedure to Upgrade EMCP 1, EMCP 2, EMCP 2+, EMCP 3.1, EMCP 3.2, and EMCP 3.3 to EMCP 4.2 {4490, 7451}
C7 and C9 Industrial Engines Diagnostic Trouble Codes
C7 and C9 Industrial Engines Diagnostic Trouble Code Cross Reference
G3304B and G3306B Engines Exhaust Manifold - Install
3500E EPA Tier 4 Final and IMO-II/III Switchable Marine Engines Aftertreatment SCR System Dosing - Test
C11, C13, C15, and C18 Industrial Engines NOx Reduction System (NRS) - Test
G3612 and G3616 Engines Rocker Arm - Install
C18 Industrial Engine Sensor Supply - Test
G3612 and G3616 Engines Gas Admission Valve - Remove
C11, C13, C15, and C18 Industrial Engines Solenoid Valve - Test
G3612 and G3616 Engines Gas Admission Valve - Install
2015/05/15 New Generators on Certain C2.2 Marine Generator Sets {4450}
G3612 and G3616 Engines Valve Mechanism - Remove
C2.2 Engines For Caterpillar Built Machines Injector Solenoid - Test
C11, C13, C15, and C18 Industrial Engines Variable Valve Actuator Response - Test
C8.7 Marine Engine Camshaft - Remove and Install