Aftertreatment Filter Maintenance on Large Engine Tier 4 Interim and Final Products Equipped with a Selective Catalyst Reduction (SCR) Filter{1075, 108H, 1920}
- Engine:
- 3516C (S/N: SKC1-UP; TKG1-UP; SCJ1-UP; TKJ1-UP; SCK1-UP; SFK1-UP; TKK1-UP)
- C175-16 (S/N: WYC1-UP)
Introduction
When the SCR catalyst is replaced on any Tier 4 Interim or Tier 4 Final Engine, the following procedure must be used. The procedure will ensure that the catalyst life is reset within the ECM.
Do not perform any procedure in this Special Instruction until you have read this entire Special Instruction and you understand this information.
Selective Catalytic Reduction (SCR) Maintenance on Tier 4 Interim and Final Products
The Aftertreatment SCR Catalyst Replacement procedure must be performed when the SCR Catalyst has been replaced. This procedure is necessary to ensure that the engine meets emissions requirements. Follow the procedure below to reset the SCR Catalyst model in the aftertreatment software.
- Connect to Cat® ET.
- Connect to "Selective Catalyst Reduction System".
- Select "Service" from the top menu and select "Service Procedures".
- Select "Aftertreatment #1 SCR Catalyst Replacement" and select "Start".
Show/hide table
Illustration 1 | g03806105 |
- Select "Reset".
Show/hide table
Illustration 2 | g03740210 |
- Read the warning and select "Accept" in order to continue.
Show/hide table
Illustration 3 | g03740216 |
- Enter the factory passwords to continue.
- Once the reset is completed, a log of the reset is captured and visible as a new row of information in the "Aftertreatment #1 SCR Catalyst Replacement" screen.
Show/hide table
Illustration 4 | g03740230 |
Caterpillar Information System:
G3612 and G3616 Engines Prelubrication Oil Pump - Remove and Install
G3600 A4 Engines Electronic Service Tools
2015/03/02 New Phone Number for VIMS Support Is Now Available for All Cat® Products Equipped with VIMS {7601}
C13 Engines Monitoring System
C13 Engines Reference Information
DE Series Generator Sets With Cat C3.3 Engine Maintenance Interval Schedule - Standby
DE Series Generator Sets With Cat C3.3 Engine Maintenance Interval Schedule - Prime Power
C13 Engines Emissions Certification Film
C13 Engines Plate Locations and Film Locations
G3516 TA Engine ECM - Replace
3512E Tier 4 Final Engines for Land Electric Drilling Injector Solenoid - Test
C3.4B Engines for Caterpillar Built Machines Aftertreatment SCR System Dosing - Test
C9.3 Marine Auxiliary and Generator Set Engine Crankcase Pressure Is High
C13 Engines Diagnostic Flash Code Retrieval
C13 Engines Diagnostic Lamp
C27 Industrial Engine and C27 Locomotive Engine Maintenance Interval Schedule
G3600 A4 Engines Lubrication System
G3612 and G3616 Engines Engine Oil Pump - Remove and Install
DE Series Generator Set with Cat C1.1, C1.5, and C2.2 Engines Refill Capacities and Recommendations
C13 Engines Engine Operation
DE Series Generator Sets With Cat C3.3 Engine Refill Capacities and Recommendations
C9.3 Marine Auxiliary and Generator Set Engine Engine Does Not Crank
C9.3 Marine Auxiliary and Generator Set Engine Engine Has Early Wear
3512E Land Electric Drive Fuel System - Prime