3512E Land Electric Drive Caterpillar


Fuel System - Prime

Usage:

3512E BZ3
The Electric Priming Pump (EPP) is used to prime the fuel system prior to attempting to start the engine. The fuel priming cycle is an 8 minute cycle.


    Illustration 1g03806798
    (1) Fuel priming switch

  1. Open the fuel supply valve. Ensure that the engine will not start during the priming procedure. Turn the engine start switch to the OFF position.

  2. Hold switch (1) for the electric fuel priming pump in the ON position for 2 seconds. Holding the switch in the ON position for 2 seconds will engage the priming cycle which will run for 8 minutes. The switch is a momentary switch.

  3. Perform step 2 for 2 complete 8 minute cycles.

Caterpillar Information System:

C9.3 Marine Auxiliary and Generator Set Engine Engine Has Early Wear
C9.3 Marine Auxiliary and Generator Set Engine Engine Does Not Crank
DE Series Generator Sets With Cat C3.3 Engine Refill Capacities and Recommendations
C13 Engines Engine Operation
DE Series Generator Set with Cat C1.1, C1.5, and C2.2 Engines Refill Capacities and Recommendations
G3612 and G3616 Engines Engine Oil Pump - Remove and Install
G3600 A4 Engines Lubrication System
C27 Industrial Engine and C27 Locomotive Engine Maintenance Interval Schedule
C13 Engines Diagnostic Lamp
C13 Engines Diagnostic Flash Code Retrieval
C9.3 Marine Auxiliary and Generator Set Engine Crankcase Pressure Is High
Aftertreatment Filter Maintenance on Large Engine Tier 4 Interim and Final Products Equipped with a Selective Catalyst Reduction (SCR) Filter{1075, 108H, 1920} Aftertreatment Filter Maintenance on Large Engine Tier 4 Interim and Final Products Equipped with a Selective Catalyst Reduction (SCR) Filter{1075, 108H, 1920}
G3612 and G3616 Engines Engine Oil Coolers - Remove and Install
C7.1 Marine Generator Set Engine Oil Pressure - Test
C9.3 Marine Auxiliary and Generator Set Engine Engine Has Mechanical Noise (Knock)
C9.3 Marine Auxiliary and Generator Set Engine Engine Misfires, Runs Rough or Is Unstable
C9.3 Marine Auxiliary and Generator Set Engine Engine Overcrank Occurrence
C9.3 Marine Auxiliary and Generator Set Engine Engine Overspeeds
C9.3 Marine Auxiliary and Generator Set Engine Engine Stalls at Low RPM
C9.3 Marine Auxiliary and Generator Set Engine Engine Top Speed Is Not Obtained
2015/03/04 New Software Is Now Available for All Cat® Products With PL522 China System {7606, 7620}
C13 Engines Configuration Parameters
C13 Engines Compression Brake - If Equipped
G3612 and G3616 Engines Engine Oil Filter Housings - Remove and Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.