C13 Generator Set Engine Caterpillar


Engine Oil Pump - Remove and Install

Usage:

C13 XQ375 X3F

Removal Procedure

  1. Drain the coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedures.


    Illustration 1g03761978

  2. Disconnect hose assembly (1).


    Illustration 2g03762177

  3. Disconnect hose assembly (3) and hose assembly (5).

  4. Loosen clamps (6) and remove hose (7).

  5. Remove bolts (2) and water pump elbow (4).


    Illustration 3g03762217

  6. Remove bolts (8), bolts (10), and oil manifold (9).


    Illustration 4g03763636

  7. Remove bolts (11), bolts (13), and bolts (14). Remove guard assembly (12).


    Illustration 5g03763756

  8. Remove bolt (15), stud (17), and engine oil pump (16).

Installation Procedure

Note: Lubricate all O-ring seals during installation with the lubricant that is being sealed.

  1. Install engine oil pump (16) in the reverse order of removal.

Caterpillar Information System:

G3600 A4 Engines Electrohydraulic System Oil Filter - Change
G3600 A4 Engines Electrohydraulic System Oil - Change
C13 Generator Set Engine Engine Oil Cooler - Remove and Install
G3600 A4 Engines Electrohydraulic System - Inspect
G3600 A4 Engines Electrohydraulic Actuator - Recondition
G3600 A4 Engines Engine Operation
G3600 A4 Engines Configuration Parameters
G3600 A4 Engines Monitoring System
G3600 A4 Engines Control Panel
C13 Generator Set Engine Engine Oil Filter Base - Remove and Install
C7.1 Engines DEF Module Does Not Respond
C7.1 Engines DEF Does Not Purge
C15 and C18 Engines Maintenance Interval Schedule - C15 Engines With Ratings Greater Than 579 hp
C15 and C18 Engines Maintenance Interval Schedule - C15 Engines
C15 and C18 Engines Maintenance Interval Schedule - C18 Engines
C15 and C18 Engines Maintenance Interval Schedule - C18 Engines With Ratings Greater Than 760 HP
C32 Marine Engines Auxiliary Water Pump - Disassemble
C7.1 Engines DEF Pressure Is Low
2014/11/26 New Electrical Schematic Is Available for Certain Retrofit Aftertreatment Selective Catalytic Reduction Systems {108F, 1091, 7566}
2015/02/27 A New Procedure Exists for Marking Diesel Particulate Filters that Are Being Returned to Cat ® Reman {108F, 7754}
2015/01/16 A New Air Starter Service Kit and Strainer Are Used on the Air Starting Systems of Certain C27, C32, 3512, and 3516C Engines {1451}
C13 Generator Set Engine Water Pump - Remove and Install
3512E Land Electric Drive Manual Stop Procedure
NEHS1214: 455-0126 Nitrogen Booster Pump Group {0374, 0599, 0647, 0756, 4263, 4331, 5077, 7200} NEHS1214: 455-0126 Nitrogen Booster Pump Group {0374, 0599, 0647, 0756, 4263, 4331, 5077, 7200}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.