Electrohydraulic System Oil Filter - Change
Show/hide table
 | |
| 图 1 | g03761878 |
(1) 滤清器 (2) 目测表 (3) 加注口盖 | |
- 用 1U-8760 链条扳手 拆下滤清器 (1) 。
- 清洁安装底座的密封表面。 确保所有旧滤清器密封垫都已清除干净。
- 在新的滤清器密封垫上涂抹清洁的液压油。
Show/hide table
 | |
| 图 2 | g00103713 |
典型的滤清器安装底座和密封垫 | |
注: 有关使用的正确机油，请参见本操作和保养手册, "加注容量和建议"专题（保养部分）。
- 用手安装滤清器。 旋拧滤清器直到密封垫接触到安装底座。 根据滤清器上的说明拧紧滤清器。 不要过度拧紧滤清器。
- 起动发动机。 观察目测表 (2) 内的油位。 油位应介于标注在油箱上的 "ADD（加）"和 "FULL（满）"标记之间。 如果需要，拆下机油加注口盖 (4) 。 将正确的机油加入机油加注口。 清洁机油滤清器加注口盖。 安装机油滤清器加注口盖。
Caterpillar Information System:
G3600 A4 Engines Electrohydraulic System Oil - Change
C13 Generator Set Engine Engine Oil Cooler - Remove and Install
G3600 A4 Engines Electrohydraulic System - Inspect
G3600 A4 Engines Electrohydraulic Actuator - Recondition
G3600 A4 Engines Engine Operation
G3600 A4 Engines Configuration Parameters
G3600 A4 Engines Monitoring System
G3600 A4 Engines Control Panel
C13 Generator Set Engine Engine Oil Filter Base - Remove and Install
C7.1 Engines DEF Module Does Not Respond
C7.1 Engines DEF Does Not Purge
C7.1 Engines DEF Control Module Temperature Is High
C13 Generator Set Engine Engine Oil Pump - Remove and Install
C15 and C18 Engines Maintenance Interval Schedule - C15 Engines With Ratings Greater Than 579 hp
C15 and C18 Engines Maintenance Interval Schedule - C15 Engines
C15 and C18 Engines Maintenance Interval Schedule - C18 Engines
C15 and C18 Engines Maintenance Interval Schedule - C18 Engines With Ratings Greater Than 760 HP
C32 Marine Engines Auxiliary Water Pump - Disassemble
C7.1 Engines DEF Pressure Is Low
2014/11/26 New Electrical Schematic Is Available for Certain Retrofit Aftertreatment Selective Catalytic Reduction Systems {108F, 1091, 7566}
2015/02/27 A New Procedure Exists for Marking Diesel Particulate Filters that Are Being Returned to Cat ® Reman {108F, 7754}
2015/01/16 A New Air Starter Service Kit and Strainer Are Used on the Air Starting Systems of Certain C27, C32, 3512, and 3516C Engines {1451}
C13 Generator Set Engine Water Pump - Remove and Install
3512E Land Electric Drive Manual Stop Procedure