Turbocharger
Show/hide table
 | |
| Illustration 1 | g03723002 |
Typical example | |
(1) Tighten the studs to the following torque. ... 18 N·m (13 lb ft)
(2) Tighten the nuts to the following torque. ... 55 N·m (41 lb ft)
(3) Tighten the bolts to the following torque. ... 55 N·m (41 lb ft)
Caterpillar Information System:
C7.1 Marine Engine Flywheel
C7.1 Marine Engine Flywheel Housing
C3.4B Engines Electrical Power Supply - Test
3516C and C175-16 Engines Selective Catalytic Reduction Configuration Parameters
CAT Water Delivery System (WDS) and 777G WTR OEM Off-Highway Truck/Tractor Pump Drive - Assemble
C18 Fire Pump Engine Model View Illustrations
C18 Fire Pump Engine Engine Electronics
Air Conditioning and Heating R134a for All Caterpillar Machines General Troubleshooting Information
Air Conditioning and Heating R134a for All Cat Machines General Information
Troubleshooting Procedure for the AGC-4 Generator Controller{4490} Troubleshooting Procedure for the AGC-4 Generator Controller{4490}
794 AC Off-Highway Truck Final Drive Oil - Change
Spring Isolator Installation and Adjustment Procedure for Certain Generator Sets with 3500 Gas Engines{1021, 7002} Spring Isolator Installation and Adjustment Procedure for Certain Generator Sets with 3500 Gas Engines{1021, 7002}
C7.1 Marine Engine Fuel Injection Lines
C7.1 Marine Engine Fuel Filter Base
C7.1 Marine Engine Fuel Manifold (Rail)
C7.1 Marine Engine Exhaust Manifold
2015/02/10 New Bearings with a Reduced Inside Diameter are Available for the Elimination of Radial Play in the Front Linkage for Certain D Series and E Series Excavators, Forest Machines, and Mobile Hydraulic Power Units {6513}
3516E Generator Set Engine Aftercooler - Two Stage Aftercooler
C0.5 and C0.7 Industrial Engines Severe Service Application
XQC1200 Power Module Fan Motor - Lubricate
XQ2000 Power Module Fuel Tank Strainer - Clean
XQ125 Generator Set Clean Emissions Module Support - Inspect
C4.4 Engines for Caterpillar Built Machines Fuel Injection
C3.4B Engines Glow Plug Starting Aid - Test