Cooling System Coolant Level - Check
Provjerite razinu rashladne tekućine pri zaustavljenom i hladnom motoru.
Show/hide table
Ilustracija 1 | g00285520 |
Čep za punjenje rashladnog sustava |
Show/hide table
Sustav pod tlakom: Vruća rashladna tekućina može prouzročiti ozbiljne opekline. Za otvaranje poklopca za punjenje rashladnog sustava zaustaviti motor i pričekati dok se dijelovi rashladnog sustava ohlade. Polako otpustiti tlačni poklopac rashladnog sustava, kako bi se ispustio tlak. |
- Polako uklonite čep za punjenje rashladnog sustava kako bi se oslobodio tlak.
- Održavajte razinu rashladne tekućine unutar
13 mm (0.5 inch) od dna cijevi za punjenje. Ako je motor opremljen staklom mjerača, održavajte razinu rashladne tekućine na propisnoj razini na staklu mjerača. - Očistite čep za punjenje rashladnog sustava i provjerite stanje brtava čepa za punjenje. Ako su brtve oštećene, zamijenite poklopac za punjenje rashladnog sustava. Ponovno montirajte poklopac za punjenje rashladnog sustava.
- Provjerite ima li propuštanja u rashladnom sustavu.
Caterpillar Information System:
DE Series Generator Set With Cat C7.1 Engine Cooling System Coolant Extender (ELC) - Add
DE Series Generator Set With Cat C7.1 Engine Cooling System Coolant (ELC) - Change
DE Series Generator Set With Cat C7.1 Engine Alternator Belt - Inspect/Adjust/Replace
DE Series Generator Set With Cat C7.1 Engine Battery or Battery Cable - Disconnect
DE Series Generator Set With Cat C7.1 Engine Battery Electrolyte Level - Check
DE Series Generator Set With Cat C7.1 Engine Battery - Replace
DE Series Generator Set With Cat C7.1 Engine Alternator - Inspect
DE Series Generator Set With Cat C7.1 Engine Engine Identification
DE Series Generator Set With Cat C7.1 Engine Plate Locations and Film Locations
G3306B Petroleum Generator Set Engines Aftertreatment Identification Module - Test
824K Wheel Dozer, 825K Soil Compactor and 826K Landfill Compactor Machine Systems Pressure Sensor
ACERT Cylinder Heads Are Used in the "Platinum" Rebuild Kits for Certain 3406E, C-15, and C-16 Truck Engines {1000, 1100} ACERT Cylinder Heads Are Used in the "Platinum" Rebuild Kits for Certain 3406E, C-15, and C-16 Truck Engines {1000, 1100}
DE Series Generator Set With Cat C7.1 Engine Cooling System Water Temperature Regulator - Replace
390F Excavator Machine Systems System Pressure - Release
G3408 and G3412 Engines Spark Plug Wires - Replace
390F Excavator Machine Systems Duo-Cone Conventional Seals - Install
C175-16 Petroleum Engines Electronic Control Module (ECM)
2014/11/06 An Improved Fastening Process for the Number Two Clutch Seal Housing is Used on Certain CX31 and CX35 Transmissions {3160}
390F Excavator Machine Systems Bucket - Remove and Install
390F Excavator Machine Systems Bucket Linkage - Remove and Install
C175-16 Petroleum Engine System Overview
390F Excavator Machine Systems Bucket Linkage Bearings and Seals - Remove and Install
390F Excavator Machine Systems Gear Pump (Pilot) - Remove and Install
DE Series Generator Set With Cat C7.1 Engine Engine - Clean