Diesel Exhaust Fluid Module - Disassemble
拆解步骤
开始:
- 拆下柴油机排气处理液管路。 有关正确步骤,请参阅拆解和装配, "柴油机排气处理液管路 - 拆卸和安装"。
- 拆下电压负载保护模块。 有关正确步骤,请参阅拆解和装配, "电压负载保护模块 - 拆卸和安装"。
- 拆下电子控制(柴油机排气处理液)。 有关正确步骤,请参阅拆解和装配, "电子控制(柴油机排气处理液)- 拆卸和安装"。
- 拆下歧管(DEF 加热器)。 有关正确步骤,请参阅拆解和装配, "歧管(DEF 加热器)- 拆卸和安装"。
- 拆下电磁阀(DEF 加热器冷却液)。 有关正确步骤,请参阅拆解和装配, "电磁阀(DEF 加热器冷却液)- 拆卸和安装"。
Show/hide table
注意 |
---|
在检验、保养、测试、调整及维修产品时,务必留心,确保液体盛装在容器中。 在打开任何腔室或拆解任何储有液体的部件之前,要准备好用合适的容器收集液体。 按照本地法规和指令处置所有液体。 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将蓄电池断路开关转到断开位置。
- 将线束组件 (5) 从继电器 (3) 上断开。
Show/hide table
图 1 | g03421223 |
- 将线束组件 (6) 从继电器 (4) 上断开。
- 将螺栓 (1) 从继电器 (3) 上拆下。 将继电器从支架上拆下。
- 将螺栓 (2) 从继电器 (4) 上拆下。 将继电器从支架上拆下。
- 在线束组件 (9) 上作临时标记,以便于安装。
Show/hide table
图 2 | g03421235 |
- 作临时标记,以显示所有电缆扎带的位置,以便于安装。 将电缆扎带 (7) 和 (8) 从线束组件 (9) 上切断。
- 将线束组件 (9) 从支架上拆下。
- 拆下柴油机排气处理液泵 (10) 。 有关正确步骤,请参阅拆解和装配, "柴油机排气处理液泵 - 拆卸和安装"。
- 将螺栓 (13) 从支架 (12) 上拆下。
Show/hide table
图 3 | g03421327 |
- 将支架 (12) 从支架 (11) 上拆下。
- 将螺栓 (15) 从支架 (11) 上拆下。
Show/hide table
图 4 | g03421330 |
- 将支架 (11) 从罐 (16) 上拆下。
- 如有必要,将加注口盖 (14) 从罐 (16) 上拆下。 部分应用上可能采用其他类型的加注口盖。 有关正确的拆卸步骤,请参阅原始设备制造商 (OEM) 信息。
Caterpillar Information System:
C15 and C18 Engines for Caterpillar Built Machines Fuel Filter and Water Separator
C13 Industrial Engine Injector (Diesel Exhaust Fluid) - Replace
3512C Petroleum Engines Electronic Control Module (Engine) - Remove and Install
2014/01/17 Special Instructions Are Available for Retrofitting the Dynamic Gas Blending Kits on Certain 3512B Engines {1250, 1280}
2013/10/17 A New Expansion Tank Assembly Is Used on Certain 3500 Marine Engines {1354}
C7.1 Industrial Engine Manifold (DEF Heater) - Remove and Install
C7.1 Industrial Engine Solenoid Valve (DEF Heater Coolant) - Remove and Install
3516C Petroleum Engines Engine Oil Pressure Sensor - Remove and Install
3512E HD Petroleum Engine Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace - If Equipped
3512C Oil Well Service Engines Declaration of Conformity
435-8503 Major Engine Overhaul Foundational Kit for 3406E Marine Engines{1000} 435-8503 Major Engine Overhaul Foundational Kit for 3406E Marine Engines{1000}
3516C Petroleum Engines Engine Speed/Timing Sensor - Remove and Install
C7.1 Industrial Engine Diesel Exhaust Fluid Module - Assemble
2013/11/21 A New Jacket Water Outlet Elbow Is Used on Certain C175 Marine and Petroleum Engines {1380}
3512C Petroleum Engines Gas Pressure Regulator - Remove and Install
C7.1 Engines NOx Conversion Is Low
3512C Petroleum Engines Fuel Control Actuator - Remove and Install - Dynamic Gas Blending
C32 Auxiliary Engine Engine Electronics
2013/07/25 A New Coupling Assembly Is Used on Heat Exchangers for Certain 3500B and 3500C Engines {1379}
2013/07/25 New Software Flash File Extension Requires Caterpillar Electronic Technician (Cat ET) 2013B {0785, 7620}
349F and 352F Excavators Hydraulic System Solenoid Valve (Proportional Reducing) - Power Shift System
349F and 352F Excavators Hydraulic System Relief Valve (Main) - Heavy Lift
349F and 352F Excavators Machine System Control Valve (Boom Lowering)
2013/07/30 Delphi Fuel Injection Pumps on 3054, 3056, 3054B, 3054C, C3.3, C4.4 (MECH), and C7.1 (MECH)Engines {1251}