C15 and C18 Industrial Engines Caterpillar


Vibration Damper and Pulley - Remove and Install

Usage:

C15 N5F

拆卸步骤

表 1
所需工具 
工具  零件号  零件描述  数量 
A  −  导向螺栓
1/2 - 13 NF x 8 in 
B  4C-5593  螺纹润滑剂  − 


注意

保持所有零件清洁无杂质。

杂质会造成快速磨损和缩短部件寿命。


  1. 卸下皮带。 参考操作和保养手册, "皮带 - 检查"。


    图 1g03400456

  2. 拆下螺栓 (1) ,然后拆下皮带轮 (2)。


    图 2g03400523

  3. 拆下两个螺栓,安装工具 (A)。 拆下螺栓 (3 )。 由两个人拆下减振器 (4)。 减振器的重量约为 36 kg (80 lb)

安装步骤

  1. 按相反顺序安装减振器 (4)。

    1. 将工具 (B) 涂抹在螺栓 (1) 上。

    2. 拧紧螺栓 (1) 至扭矩为 270 ± 40 N·m (200 ± 30 lb ft)

Caterpillar Information System:

C7 Petroleum Engine Coolant Sample (Level 2) - Obtain
374F Excavator Hydraulic System General Information (Travel System)
UPS 120, UPS 150, UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Modbus Register Map
Well Service Pumps System Pressure Release
C15 and C18 Industrial Engines Engine Oil Filter Base - Remove and Install
Caterpillar Petroleum Hydraulic Fracturing Transmission Installation Appraisal Procedures{3030} Caterpillar Petroleum Hydraulic Fracturing Transmission Installation Appraisal Procedures{3030}
C15 and C18 Industrial Engines Engine Oil Cooler - Remove and Install - C15 and C18
Well Stimulation Pumps Specifications
Retrofit SCR Aftertreatment Monitoring System
2013/08/13 A New Auxiliary Sea Water Pump and Sleeves Are Used for Certain C32 Engines {1371}
Well Stimulation Pumps Pump (Fluid End) Discharge Flanges and Seals - Inspect
C7.1 Marine Generator Set Fuel System Secondary Filter - Replace
374F Excavator Hydraulic System Electronic Control (Travel System)
C7 Petroleum Engine Coolant (DEAC) - Change
C7 Petroleum Engine Refill Capacities
C7 Petroleum Engine Fluid Recommendations
3500B and 3500 Marine Propulsion Engines with EUI Option Hoses and Clamps - Replace
C15 and C18 Industrial Engines Cylinder Head - Remove and Install
300.9D and 300.9D VPS Mini Hydraulic Excavator Crushing Prevention and Cutting Prevention
301.5, 301.6, 301.7 CR, 301.8 and 302 CR Mini Hydraulic Excavators Operating Technique Information
301.5, 301.6, 301.7 CR, 301.8 and 302 CR Mini Hydraulic Excavators Quick Coupler Operation - Manual Pin Grabber Quick Coupler (If Equipped)
C15 and C18 Industrial Engines Engine Oil Pan - Remove and Install
Engine Oil Contains Elevated Lead (Pb) {1348} Engine Oil Contains Elevated Lead (Pb) {1348}
2014/02/17 An Improved Foot Valve Assembly for the Fuel Transfer Pump Is Now Available as a Service Replacement on Certain 300D and 300E Series Excavators and Mobile Hydraulic Power Units {1256}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.