Piston Cooling Jet
Show/hide table
 | |
| Illustration 1 | g03346297 |
Show/hide table
| Specification for 391-1392 Piston Cooling Jet Gp | |||
| Item | Qty | Part | Specification Description |
| - | - | - | The piston cooling jet must be checked for the location of the stream of oil. Insert a drill rod with a diameter of 2.0 mm (0.08 inch) into the orifice. The drill rod simulates the stream of oil under normal operating pressure. The drill rod must pass through a circle with a diameter of 5.6 mm (0.22 inch) at point (1). |
| - | - | - | Use the following dimensions in order to locate point (1) : Dimension (A) is 27.80 ± 0.25 mm (1.094 ± 0.010 inch). Dimension (B) is 21.51 ± 0.25 mm (0.847 ± 0.010 inch). Dimension (C) is 250.00 ± 0.25 mm (9.843 ± 0.010 inch). Dimension (D) is 250.00 ± 0.25 mm (9.843 ± 0.010 inch). |
Caterpillar Information System:
C7.1 Engines for Caterpillar Built Machines Fuel Injection Pump
C7.1 Engines for Caterpillar Built Machines Electronic Control Module
C18 Marine Propulsion Engines Crankshaft
C32 Marine Engines Auxiliary Water Pump - Sea water
C7.1 Engines for Caterpillar Built Machines Crankshaft Seals
C7.1 Engines for Caterpillar Built Machines Fuel Manifold (Rail)
C7.1 Engines for Caterpillar Built Machines Engine Oil Pump
C18 Marine Propulsion Engines Auxiliary Water Pump - Sea Water
C7.1 Engines for Caterpillar Built Machines Speed/Timing Sensor
C18 Marine and Marine Generator Set Engines Auxiliary Water Pump - Sea Water
2013/02/22 Bearing Upgrade from Pre 2.4 or 2.4 Bearings to 3.5 Bearing on Certain Uninterruptible Power Supply {4480, 7551}
3512B, 3512C, and 3516B Petroleum Engines and Petroleum Generator Set Engines with Dynamic Gas Blending Fuel Pressure Problem - Gas System
C9.3 Engines for Caterpillar Built Machines DEF Injector and Mounting - Remove and Install
2013/04/17 Flexible Fuel Lines Groups Are Used for Certain 3500 Locomotive Engines {1274}
C27 and C32 Tier 4 Final Marine Engines Exhaust Elbow
C4.4 Industrial Engine Starting the Engine
2013/04/17 A New Turbocharger Support Assembly Is Used on C280-8 and 3608 Engines {1052}
C7.1 Engines for Caterpillar Built Machines Crankcase Breather
C7.1 Engines for Caterpillar Built Machines Fuel Filter Base - Twin Secondary Fuel Filter Base
C4.4 Industrial Engine Cold Weather Operation
C13, C15, and C18 Tier 4 Interim Engines Codes that Inhibit Operation of Aftertreatment System
C7.1 Industrial Engine Fluid Recommendations - Engine Oil
C9.3 Engines for Caterpillar Built Machines Solenoid Valve (ARD Fuel) - Remove and Install
C4.4 Industrial Engine Fluid Recommendations - Fuel