Balancer
Show/hide table
 | |
| Illustration 1 | g03340077 |
Typical example | |
(1) Tighten the setscrews that retain the balancer to the cylinder block to the following torque. ... 52 N·m (38 lb ft)
The backlash between the crankshaft gear and the balancer gear ... 0.2 to 0.4 mm (0.00787 to 0.01575 inch)
Note: The balancer has shims to reduce the backlash on the balancer gear.
Caterpillar Information System:
3500 Industrial Engines Air Starting Motor
3508B Industrial Engines Crankcase Breather
3500 Industrial Engines Air Starting Motor
3508B Industrial Engines Camshaft
3500 Industrial Engines Air Starting Motor
3512B and 3512C Petroleum Generator Set Engines Engine Oil Lines
3508B Industrial Engines Air Starting Motor Pressure Regulating Valve
2012/11/30 New Taperlock Studs for Certain G3406, G3408 , and G3412 Engines {1057, 7553}
390F Excavator Specifications
3512B, 3512C, and 3516B Petroleum Engines and Petroleum Generator Set Engines with Dynamic Gas Blending Switch Circuits - Test
TA2 Technical Inspection for Certain 3512B and 3512C Petroleum Engines{1000} TA2 Technical Inspection for Certain 3512B and 3512C Petroleum Engines{1000}
3512B, 3512C, and 3516B Petroleum Engines and Petroleum Generator Set Engines with Dynamic Gas Blending Sensor Calibration Required - Test
3500B Engines Turbocharger
C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel Transfer Pump
3516B Engine Fuel Filter Base - Remove and Install
Lip Type Seals {0599, 0733, 5050, 7555} Lip Type Seals {0599, 0733, 5050, 7555}
3512B, 3512C, and 3516B Generator Set Engines with Dynamic Gas Blending Fuel System Operation
3500 Industrial Engines Air Cleaner
3500 Industrial Engines Engine Oil Sump Pump
C1.5 and C2.2 Engines for Caterpillar Built Machines Crankcase Breather
3500B Engines Radiator
C1.5 and C2.2 Industrial Engines Exhaust Cooler (NRS) - If equipped
C1.5 and C2.2 Engines for Caterpillar Built Machines Exhaust Combustion (ARD)
C1.5 and C2.2 Engines for Caterpillar Built Machines Engine Lifting Bracket