Brush Length - Check
Show/hide table
Illustration 1 | g03224656 |
Brush length check (1) Brush (X) Brush length |
New length:
K1, 24V 2Y-4212 Charging Alternator Gp ... 10 mm (0.39 inch)
K1, 24V 2Y-8310 Charging Alternator Gp ... 13 mm (0.51 inch)
K1, 12V, and N1, 24V Charging Alternator Gp ... 17 mm (0.67 inch)
Minimum length:
K1, 24V Charging Alternator Gp ... 8 mm (0.31 inch)
K1, 12V, and N1, 24V Charging Alternator Gp ... 11.5 mm (0.45 inch)
- If the brushes are worn near or below the minimum length, replace the brushes.
Caterpillar Information System:
Alternator - Bosch K1/N1 Brush Assembly - Test
Alternator - Bosch K1/N1 Alternator
Alternator - Bosch K1/N1 Rectifier - Test
C18 Marine Engine Engine Speed/Timing Sensor - Clean/Inspect
2013/04/12 New Software Is Now Available for Cat® Product Link 522 Systems {7494, 7606, 7620}
C18 Marine Engine Belts - Inspect/Adjust/Replace
C18 Marine Engine Plate Locations and Film Locations
C18 Marine Engine Safety Messages
C18 Marine Engine Product Description
Alternator - Bosch K1/N1 Field Winding - Test
C175-16 and C175-20 Locomotive Engines Engine Oil Pan - Assemble
Alternator - Bosch K1/N1 Stator - Test
Alternator - Bosch K1/N1 Regulator - Test
3612 and 3616 Engines Fuel Injection Lines Group
Alternator - Bosch K1/N1 Diode Trio - Test
C175-16 Locomotive Engine Engine Oil Pan - Install
C18 Marine Engine Zinc Rods - Inspect/Replace
C18 Marine Engine Fumes Disposal Filter Element - Replace
C18 Marine Engines Sensor Signal (Analog, Active) - Test
C175-16 Locomotive Engine Crankcase Breather - Remove and Install
C175-16 Locomotive Engine Valve Cover - Remove and Install
2012/09/17 Procedure to Program Injector Trim Files When Injector Trim Files Are Missing in the ECM of Certain Engines {1290, 1920}
C175-16 and C175-20 Locomotive Engines Rocker Shaft and Push Rods - Remove
2013/08/06 New Injectors Are Used In Certain C7 and C9 Commercial Engines {1251, 1290}