Brush Assembly - Test
Brush Continuity Test
- Put the multimeter on the 200 ohm resistance (Ω) scale. Touch the multimeter leads between positive (+) brush (1) and terminal (2) .
Show/hide table
Illustration 1 | g03224618 |
Brush continuity test (1) Positive (+) brush (2) Terminal |
- The multimeter reading should .1 to .3 ohms. If the resistance is not correct, the positive (+) brush (1) is open or shorted and the brushes must be replaced.
Brush Ground Test
- Put the multimeter on the 20 ohm resistance (Ω) scale. Touch the multimeter leads between negative (-) brush (3) and terminal (2) .
Show/hide table
Illustration 2 | g03224636 |
Brush ground test (2) Terminal (3) Negative (-) brush |
- The multimeter reading should be 100000 ohms or greater (meter reading 0.10 or greater). If the resistance is low, the brush is grounded and the brushes must be replaced.
Caterpillar Information System:
Alternator - Bosch K1/N1 Alternator
Alternator - Bosch K1/N1 Rectifier - Test
C18 Marine Engine Engine Speed/Timing Sensor - Clean/Inspect
2013/04/12 New Software Is Now Available for Cat® Product Link 522 Systems {7494, 7606, 7620}
C18 Marine Engine Belts - Inspect/Adjust/Replace
C18 Marine Engine Plate Locations and Film Locations
C18 Marine Engine Safety Messages
C18 Marine Engine Product Description
Alternator - Bosch K1/N1 Field Winding - Test
C175-16 and C175-20 Locomotive Engines Engine Oil Pan - Assemble
Alternator - Bosch K1/N1 Stator - Test
G3516C and G3516E Gas Engines Circuit Breakers
Alternator - Bosch K1/N1 Brush Length - Check
Alternator - Bosch K1/N1 Regulator - Test
3612 and 3616 Engines Fuel Injection Lines Group
Alternator - Bosch K1/N1 Diode Trio - Test
C175-16 Locomotive Engine Engine Oil Pan - Install
C18 Marine Engine Zinc Rods - Inspect/Replace
C18 Marine Engine Fumes Disposal Filter Element - Replace
C18 Marine Engines Sensor Signal (Analog, Active) - Test
C175-16 Locomotive Engine Crankcase Breather - Remove and Install
C175-16 Locomotive Engine Valve Cover - Remove and Install
2012/09/17 Procedure to Program Injector Trim Files When Injector Trim Files Are Missing in the ECM of Certain Engines {1290, 1920}
C175-16 and C175-20 Locomotive Engines Rocker Shaft and Push Rods - Remove