3516C Generator Set Engines Caterpillar


Engine Oil Lines

Usage:

3516C LY6


Illustration 1g03075517
Right side view


Illustration 2g03075518
Front view

Table 1
Specification for 376-3361 Engine Oil Lines Gp 
Item  Qty  Part  Specification Description 
6B-9202 Spring  Length under test force is 68.3 mm (2.69 inch).
Test force is 85 to 100 N (19 to 22 lb).
Free length after test is 112.7 mm (4.44 inch)
7N-7697 Plunger  The cooling jet sequence valves must start to open at a pressure difference of 130 ± 30 kPa (19 ± 4 psi).
The cooling jet sequence valves must be fully open at a pressure difference of 200 ± 30 kPa (29 ± 4 psi)
4F-8965 Bolt  Use the following tightening sequence for the clamp bolts:
1. Snugly tighten the clamp assembly (6) to the tube (5).
2. Tighten two bolts (4) of the clamp assembly to the elbow (7) to the standard torque.
3. Tighten two bolts (3) of the clamp assembly to the tube (5) to the standard torque. 
0S-1571 Bolt 
109-2332 O-Ring Seal  Lubricate the bore lightly with the clean engine oil. 
2W-1053 Plug  Torque to 100 ± 15 N·m (74 ± 11 lb ft)
10  2W-1635 Spring  Length under test force is 102.0 mm (4.02 inch).
Test force is 518 ± 26 N (116 ± 6 lb).
Free length after test is 143.4 mm (5.65 inch).
The oil cooler bypass valve must open with a pressure difference of 180 ± 20 kPa (26 ± 3 psi)
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.