G3500 Engines Caterpillar


Camshaft Bearing Position

Usage:

G3516 4EK



图 1g03022417

右视图

表 1
350-1417 缸体 的技术规格    
项目     数量     零件     技术规格说明    
将凸轮轴轴承安装到缸体的以下位置:    
-     -     -     位置 (A) 为
2200.0 ± 1.5 mm (86.61 ± 0.06 in)。    
-     -     -     位置 (B) 为
1930.0 ± 1.5 mm (75.98 ± 0.06 in)。    
-     -     -     位置 (C) 为
1660.0 ± 1.5 mm (65.35 ± 0.06 in)。    
-     -     -     位置 (D) 为
1390.0 ± 1.5 mm (54.72 ± 0.06 in)。    
-     -     -     位置 (E) 为
1120.0 ± 1.5 mm (44.09 ± 0.06 in)。    
-     -     -     位置 (F) 为
850.0 ± 1.5 mm (33.46 ± 0.06 in)。    
-     -     -     位置 (G) 为
580.0 ± 1.5 mm (22.83 ± 0.06 in)。    
-     -     -     位置 (H) 为
310.0 ± 1.5 mm (12.20 ± 0.06 in)。    
-     -     -     位置 (J) 为
40.0 ± 1.5 mm (1.57 ± 0.06 in)。    

Caterpillar Information System:

WAVS Generic Installation Guide for Certain Cat® Products{7347, 7348} WAVS Generic Installation Guide for Certain Cat® Products{7347, 7348}
2012/05/02 New Transmission Software is Available for Certain CX31 Transmissions and Certain CT660 On-Highway Trucks {7620}
C175-16 Engine Aftercooler Core - Inspect/Clean
C175-16 Engine Fuel Tank Water and Sediment - Drain
C175-16 Engine Emergency Stopping
C175-16 Locomotive Engines Safety Messages
2012/08/28 A New Power Distribution Box and Disconnect Switch Is Used on C175-16 Generator Set Engines {1417, 1420, 4461}
Procedure for Checking Ash Build-Up Within the Diesel Particulate Filter (DPF) {108F} Procedure for Checking Ash Build-Up Within the Diesel Particulate Filter (DPF) {108F}
CT660 CX31 and CX31 HT On Highway Truck Power Train Electronic Control System System Schematic
3512C and 3516C Marine Engines Exhaust Manifold
CX48-P2300 Petroleum Transmission Lockup Clutch and Solenoid Valve (Torque Converter) - Remove and Install
3500C Marine Engines Stub Shaft (Front)
3500C Marine Engines Cylinder Block
3512C and 3516C Marine Engines Air Cleaner
G3516C and G3516E Gas Engines Gear Group (Front)
3512C and 3516C Marine Engines Air Cleaner
3512C and 3516C Marine Engines Exhaust Bypass Valve
3500C Marine Engines Alternator Mounting
G3500 Engines Gear Group (Front)
2012/05/14 New Commissioning Instructions Now Used to Ensure Correct Voltage Applied to Contactor on 3406C, C15, C18, and C9 Gen Sets {1435, 7332, 7400}
2012/05/16 A New Improved Seal Is Now Used in the Reman Water Pumps of Certain Engines {1000, 1361, 7555}
2012/05/10 A New Improved Seal Is Now Used in the Reman Water Pumps in the Engines of Certain Machines {1000, 1361, 7555}
2012/05/09 A New Improved Seal Is Now Used in the Reman Water Pumps of Certain Engines {1000, 1361, 7555}
3512C and 3516C Marine Engines Air Inlet and Exhaust Lines
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.